Sea Gull Lighting 44436 Academy Wall Light Instruction Manual
- June 9, 2024
- Sea Gull Lighting
Table of Contents
Academy 1, 2, 3, and 4 Light Wall
44436, 44437, 44438, 44439 1.0
Installation Instructions for
GENERAL RODUCT NFORMATION:
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent version may be dimmed with a standard incandescent dimmer.
LED version may be dimmed with a LED dimmer. Consult lamp manufacturer for
additional information.
This instruction shows a typical installation.
CAUTION – RISK OF FIRE
This product must be installed in accordance with the applicable installation
code by a person familiar with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Warranty
Sea Gull Lighting fixtures and components, when properly installed and under
normal conditions of use, are warranted to be free from defects in materials
and workmanship for one year from date of sale.
LED light sources are warranted for five years.
ENERGY STAR® labeled products are warranted for three years.
Sea Gull Lighting at its sole option will repair or replace, F.O.B. Factory,
freight prepaid, any Sea Gull Lighting product defective in materials or
workmanship.
Such replacement is the exclusive remedy against Sea Gull Lighting should any
of the products delivered prove defective. Invoices for labor charges and/or
charge backs for labor will be denied unless prior written approval is given.
Any modification to a Sea Gull Lighting product not made at the factory will
void the or UL ETL listing as well as the Sea Gull Lighting warranty policy.
To register your fixture, please visit our website:
SeaGullLighting.com
Install the Fixture
- Secure the mounting plate to the junction box.
- Connect the fixture to a suitable ground in accordance to local electrical codes.
- Connect the white fixture wire to the neutral power line wire with a wire nut.
- Connect the black fixture wire to the hot power line wire with a wire nut.
- Align and place the fixture base onto the mounting plate studs and secure it with the cap nuts.
- Screw the lamp(s) into the socket(s). Refer to the label on the socket for Max Wattage Information.
- Place the shade into the shade base and secure it in place with the shade screws. Repeat for remaining shades.
Caution: Over-tightening the screws may cause the glass to break and result in injury.
STOP NEED HELP?
NECESITA AYUDA?
AVEZ VOUS BESOIN AIDE-D’
If you need installation assistance, replacement parts, or have questions regarding our warranty, please call our customer care center:
1-800-347-5483
To register your fixture, please visit our website:
www.SeaGullLighting.com
SAVETHESE INSTRUCTIONS!