speedlink SL-860200-BK Gaming True Wireless In-Ear Headphone User Manual
- June 4, 2024
- speedlink
Table of Contents
speedlink SL-860200-BK Gaming True Wireless In-Ear Headphone
INITIAL PAIRING:
Take the headphones out of their charging case and select „Speed link VIVAS
Headphones” on the device you would like to connect. While pairing the LEDs on
both headphones will flash quickly. Once the headphones have paired
successfully, the LEDs will stop flashing.
PAIRING TO A RECENTLY CONNECTED DEVICE:
The headphones will automatically pair with the most recently connected device
when taken out of their charging case.
OPERATION:
Each of the following functions can be performed by tapping/pressing and
holding the touch sensor of the respective headphone.
On/off: The headphones will automatically turn on when taken out of their
charging case and turn off when put back inside. Each headphone can also be
turned on/off by pressing and holding the headphone
for five seconds.
Volume down: Single tap the left headphone.
Volume up: Single tap the right headphone.
Play/pause: Double tap either headphone.
Answer/end call: Double tap either headphone.
Previous track: Triple tap the left headphone.
Next track: Triple tap the right headphone.
Voice assistant: Press and hold the left headphone for two seconds.
Gaming mode/music mode: Press and hold the right headphone for two
seconds to switch between modes. The gaming mode activates the illumination’s
breathing effect.
CHARGING:
To charge the headphones, place them into their charging case. While charging
the LEDs of the charging case will light up.
To charge the charging case, connect it to a power source using the charging
cable provided. The charging process is indicated by the LEDs as follows:
One LED flashing: less than 25% battery
One LED lit and one LED flashing: 25-50% battery
Two LEDs lit and one LED flashing: 50-75% battery
Three LEDs lit and one LED flashing : 75-99% battery
Four LEDs lit: 100% battery
Technical support: www.speedlink.com
Safety instructions: www.speedlink.com
WEEE: Dispose the product at a recycling point. Do not dispose together
with household waste. Incorrect storage/disposal can harm the environment
and/or cause injury.
Speed link declares that this product complies with the directives listed in
the section ‘Conformity notice’.
INTENDED USE
This product is intended to be used as in-ear headphones for connecting to
tablets, mobile phones and other audio sources. Do not use near water. Clean
with a dry cloth. It contains no user-serviceable parts. Do not disassemble it
and stop using it immediately if damaged. Speed link GmbH accepts no liability
whatsoever for any damage to this product or injuries caused due to careless
or improper use or for purposes for which it is not intended.
Please keep this information for later reference.
SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
-
Please note that the failure to observe these instructions can cause product damage, explosion, fire and/or electric shocks!
-
Only use the devices as indicated in the user guide. Do not open or repair them.
-
Do not expose the devices to liquids, heat or cold.
-
Do not use the devices in a damp environment.
Clean the devices with a dry cloth. -
Keep the devices and all loose parts away from children, pets and unauthorized persons.
-
Only use the devices with the appropriate provided accessories/cables.
-
Disconnect cables from the devices if they will not be used for a long time. When disconnecting the cables, don’t pull on the cord but on the plug.
-
Don’t use cables in any way other than mentioned in the user guide; don’t bend, cut, extend, knot or step on them.
-
Do not insert any foreign objects into the openings of the devices.
-
If the devices are damaged in any way or get too hot, stop using them immediately.
-
Take caution when using devices that emit radio signals if you have a pacemaker or are dependent on other sensitive electronic life aids.
Safety instructions in further languages:
www.speedlink.com.
WARNING SYMBOLS AND MARKINGS
Lithium polymer battery.
Further information : www.speedlink.com
Avoiding hearing damage.
Further information: www.speedlink.com
CONFORMITY NOTICE
Operation of the device (the devices) may be affected by strong static,
electrical or high-frequency fields (radio installations, mobile telephones,
microwaves, electrostatic discharges). If this occurs, try increasing the
distance from the devices causing the interference.
Conformity notice in further languages:
www.speedlink.com.
CONFORMITY NOTICE
IMPORTER/MANUFACTURER:
Speed link GmbH
Im Dorf 5
27404 Heeslingen
GERMANY
Phone: (+49) 4287 9244-0
PRODUCT DETAILS:
Product no.: SL-860200-BK
Type description: VIVAS LED Gaming True Wireless In-Ear Headphones, black
THE PRODUCT COMPLIES WITH THE FOLLOWING DIRECTIVES:
RED: 2014/53/EU
RoHS: 2011/65/EU
For a full declaration of conformity, the latest user guide or FAQ, please
visit www.speedlink.com.
RF frequency range: 2.402GHz – 2.480GHz
RF power transmission: < +8dbm
Further information: www.speedlink.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>