speedlink SL-860200-BK Gaming True Wireless In-Ear Headphones User Guide
- June 3, 2024
- speedlink
Table of Contents
SL-860200-BK Gaming
True Wireless In-Ear Headphones
User Guide
GET STARTED
SL-860200-BK Gaming True Wireless In-Ear Headphones
INITIAL PAIRING:
Take the headphones out of their charging case and select „Speedlink VIVAS
Headphones” on the device you would like to connect. While pairing the LEDs on
both headphones will flash quickly. Once the headphones have paired
successfully, the LEDs will stop flashing.
PAIRING TO A RECENTLY CONNECTED DEVICE:
The headphones will automatically pair with the most recently connected device when taken out of their charging case.
OPERATION:
Each of the following functions can be performed by tapping/ pressing and holding the touch sensor of the respective headphone.
On/off:| The headphones will automatically turn on when taken out of their
charging case and turn off when put back inside. Each headphone can also be
turned on/off by pressing and holding the headphone for five seconds.
---|---
Volume down:Volume up:| Single tap the left headphone.
Volume up:| Single tap the right headphone.
Play/pause:| Double tap either headphone.
Answer/end call:Previous track: Next track:| Double tap either headphone.
Previous track: Next track:| Triple tap the left headphone.
Next track:| Triple tap the right headphone.
Voice assistant:| Press and hold the left headphone for two
Gaming mode/music mode:| Press and hold the right headphone for two seconds to
switch between modes. The gaming mode activates the
illumination’s breathing effect.
CHARGING:
To charge the headphones, place them into their charging case.
While charging the LEDs of the charging case will light up.
To charge the charging case, connect it to a power source using the charging
cable provided. The charging process is indicated by the LEDs as follows:
One LED flashing: | less than 25% battery |
---|---|
One LED lit and one LED flashing: | 25-50% battery |
Two LEDs lit and one LED flashing: | 50-75% battery |
Three LEDs lit and one LED flashing: | 75-99% battery |
Four LEDs lit: | 100% battery |
Technical support: www.speedlink.com
Safety instructions: www.speedlink.com
WEEE: Dispose the product at a recycling point. Do not dispose together
with household waste. Incorrect storage/ disposal can harm the environment
and/or cause injury.
Speedlink declares that this product complies with the directives listed in
the section ‘Conformity notice’.
INTENDED USE
This product is intended to be used as in-ear headphones for connecting to
tablets, mobile phones and other audio sources. Do not use near water. Clean
with a dry cloth. It contains no user-serviceable parts. Do not disassemble
it and stop using it immediately if damaged. Speedlink GmbH accepts no
liability whatsoever for any damage to this product or injuries caused due to
careless or improper use or for purposes for which it is not intended.
Please keep this information for later reference.
www.speedlink.com SL-860200-BK
Documents / Resources
|
speedlink SL-860200-BK Gaming True Wireless In-Ear
Headphones
[pdf] User Guide
SL-860200-BK Gaming True Wireless In-Ear Headphones, SL-860200-BK, Gaming True
Wireless In-Ear Headphones, In-Ear Headphones, Headphones
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>