HYDREL OXFORD Series Outdoor LED Wall Mounted Luminaire Instruction Manual
- June 9, 2024
- HYDREL
Table of Contents
Installation Instructions
OWEN, OXFORD SERIES
Revision Date: March 9, 2016
MOUNTING AND LAMPING / RE-LAMPING
MOUNTING FIXTURE:
- Place gasket onto back side of canopy. Using approved wire connectors, make necessary wire connections from the remote ballast to the fixture leads.
- Using the provided mounting screw, attach canopy with fixture to junction box.
LAMPING / RE-LAMPING (MH PAR-20 & PAR-30 / PAR38)
- Loosen set screw in cap with 5/64″ Allen wrench Do not remove set screw completely.
- Remove cap from body twisting slightly while pulling.
- Turn lamp counterclockwise and unscrew from socket.
- Without touching the bulb portion of the lamp, reverse step 3 to intall new lamp. If bulb has been touched, wipe off with a clean, cotton cloth.
- If o-ring is dry, lubricate lightly with high temp grease.
- Replace cap by twisting slightly while pushing.
- Tighten set screw with 5/64″ Allen wrench. DO NOT OVER
REMOTE BALLAST HOUSING
INSTALLATION:
- Remove the ballast box cover by loosening and removing machine screw.
- Run supply wire to the ballast box.
- Feed supply wire through the knock out holes in the bottom of the ballast box.
- Wire supply wire to ballast per instructions on ballast. (Failure to do so will void warranty.) Run ground wire to ground screw (labeled “GRND”) on inside of ballast box. Do not remove ballast. Doing so will void warranty.
- Wire ballast to fixture per instructions on the ballast. (Failure to do so will void warranty.)
- Coil excess wire into the ballast box.
- Re-install the machine screw that holds the ballast box cover to the ballast box.
MAXIMUM REMOTE DISTANCE:
- Maximum remote distance for the remote ballast housing is 20FT from ballast to lamp socket.
- Exceeding this remote distance may damage ballast and will void the warranty.
OWEN, OXFORD SERIES
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS
Lighted lamp is HOT!
WARNING To reduce the risk of FIRE OR INJURY TO PERSONS: Turn off/unplug
and allow to cool before replacing lamp.
Lamp gets HOT quickly! Contact only switch/plug when turning on.
Do not touch hot lens, guard, or enclosure (see diagram/picture). Keep lamp
away from materials that may burn.
Do not touch the lamp at any time. Use a soft cloth. Oil from skin may damage
lamp.
Do not operate the luminaire fitting with a missing or damages shield.
SAVE THESE INSTRUCTIONS
Power Unit:
This fixture requires a ballast for operation (Included with ballast housing).
Verify power requirements with ballast manufacturer.
Wire: Verify requirements with ballast manufacturer, national, and local
building codes.
Wire Connectors : Use silicone filled, waterproof wire nuts to make
electrical connections.
Codes: Verify conduit requirements and installation requirements for
outdoor lighting with local codes.
SAVE THESE INSTRUCTIONS!
©2014 Hydrel 3/9/2016 INS_OWEN/OXFORD
NOTE: HYDREL RESERVES THE RIGHT TO MODIFY SPECIFICATIONS WITHOUT NOTICE.
Any dimension on this sheet is to be assumed as a reference dimension: ” Used
for information purposes only. It does not govern manufacturing or inspection
requirements.” (ANSI Y14.5-1973)
One Lithonia Way Conyers GA. 30012
P: 800-705-SERV (7378)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>