OPTONICA 9047 Vintage Pendant Light Holders User Manual
- June 9, 2024
- OPTONICA
Table of Contents
OPTONICA 9047 Vintage Pendant Light Holders
VINTAGE PENDANT LIGHT HOLDERS INSTALATIONS
SKU: 9028, 9029, 9046, 9047, 9048, 9049
Product name: Vintage Pendant Light Holders
Wire specification: VDE 2×0.75mm
Wire length: 1M
Lamp holder: CE E27x1
Light source: NO
IMPORTANT
These instructions should be read carefully before use and this document
constitutes part of the product which should be kept safely by the user
alongside the product.
BEFORE USE
You must inspect the fitting dor any signs of damage. If the fitting is
damaged, DO NOT use it, AND contact your supplier immediately.
SAFETY INSTRUCTIONS
- This item should be fitted by a competent person or a qualified electrician.
- For indoor use only .
- Do not use the fitting for other than its intended use
- Check the fitting before use for damage. If any damage is detected stop using i immediately and consult your supplier
- If in doubt about any aspect of the installation, please consult a qualified electrician
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician at
least once every 10 years.
For offiece and retail premises (and buildings such as village halls) the
wiring must be inspected at least once every 5 years.
It is recommended that all buildings be fitted with smoke alarms (it is
mandatory for new buildings).
IMPORTER: Prima Group 2004 LTD, Bulgaria, 1784 Sofia, Mladost 1, bl. 144,
Ground Floor;
Phone: +359 2 988 45 72;
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>