OTTO MCE357 Infrared LED Sensor Lamp User Manual
- June 9, 2024
- OTTO
Table of Contents
OTTO MCE357 Infrared LED Sensor Lamp
Infrared LED Sensor Lamp
The product is an energy-saving automatic sensor lamp, adopting integrated circuit and precise detecting components. It gathers automatism, convenience, safety, saving-energy and practical functions. Its performance is stable. It can identify day and night. The lamp can turn on when one enters detection field and can turn off automatically when one leaves detection field.
SPECIFICATION
- Rated voltage: 220 -240V/AC Detection Range: 160°
- Rated frequency: 50/60Hz Detection Distance: max.9m(<24°C)
- Ambient Light: <3-2000LUX (adjustable) Working Temperature: -20/+40°C
- Time Delay: Min. 10sec±3sec Working Humidity: <93%RH
- Max. 5min±1min Installing Height: 1.8-2.5m
- Rated Load : 10W (950lm) Detection Motion Speed: 0.6-1.5m/s
- Colour temperature: 4000K Neutral White Material: PC
- Rated lifespan: 30 000h IP Class: IP44
- Protection class against electric shock: II Rated durability: 15000h
- This product isn’t compatible with dimmers Colour Rendering Index: Ra >=80
- Minimal distance from the objects that a lamp is illuminating: >= 0,5m
INSTALLATION
(see the diagram):
- Switch off the power.
- Unload the plastic cover to open it. (refer to figure)
- Pass the wire through the hole in the bottom and connect the power wire into connection-wire column according to the connection-wire diagram. Install the sensor lamp in the position where you need with inflated screws. (refer to figure)
- Check appropriate mechanical fastening and electrical connection before first use
- Switch on the power and test it.
TEST
Turn the TIME knob on the minimum (-). Turn the LUX knob on the maximum (sun).
- Switch on the power; the lamp will have no signal at the beginning. After Warm-up 30sec, the lamp can start work. If it receives the induction signal, the lamp will turn on. While there is no another induction signal any more, the lamp should stop working within 10sec±3sec.
- Turn LUX knob anti-clockwise on the minimum (moon). If the ambient light is more than 3LUX, the lamp should not work. If the ambient light is less than 3LUX (darkness), the sensor would work. Under no induction signal condition, the lamp should stop working within 10sec±3sec.
NOTE:
IMPORTANT: when testing in daylight, please turn LUX knob to (SUN) position, otherwise the sensor lamp could not work!
- Should be installed by electrician or experienced person;
- There should be no hindrance and moving objects in front of the detection windows to affect detection;
- Avoid installing it near air temperature alteration zones such as air condition, central heating ect.
- The manufacturer reserves the right to make design changes and improvements caused by technical progress t any products described in the manual, without notifying the user.
This product contains a light source with energy efficiency class E.
DISPOSAL
The device is marked with the symbol of a crossed-out rubbish container, in accordance with the European Directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). Products marked with this symbol should not be recycled or disposed of with other household waste at the end of their useful life. The user is obliged to dispose of waste electrical and electronic equipment by delivering it to a designated point where it is recycled. For information on where and how to dispose of used electrical and electronic equipment in an environmentally safe manner, the user should contact the relevant local authority, the waste collection point or the point of sale where they purchased the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>