OTTO Wired 6 Motorized Roller Shades User Guide

MOTORIZED ROLLER SHADES
OTTO WIRED 6
PROGRAMMING GUIDE

REMOTE CONTROL BASICS

Wall Mount Holder

Remove cover from base by prying with flat head screwdriver. Use supplied fasteners and anchors to attach the base to wall. Replace cover by pressing snap latches into place.
Remote Control Functions & Battery Replacement

WIRING

Power Options
Cut off the mains power supply
Connect the motor according to the information in the table below.

** Ensure cable is kept clear of fabric.
Ensure antenna is kept straight and away from metal objects.
Motor state test**
This table describes the function of a short P1 button press/release (<2 seconds) depending on current motor configuration.

P1 Press| Condition| Function Achieved| Visual Feedback| Audible Feedback| Function Described
---|---|---|---|---|---
Short Press| If limit is NOT set| None| No Action| None| No Action
If limits are set| Operational control of motor, run to limit.  Stop if running| Motor runs| None| Operational control of motor after pairing and limit setting is completed first time
If motor is in “Sleep Mode” & limits are set| Wake and control| Motor wakes and runs in a direction| None| Motor is restored from Sleep Mode and RF control is active

Motor configuration options
The P1 Button is utilized to administer motor configuration as described below and beginning in Section

INTIAL SET-UP

Pair motor with controller ** Motor is now in step mode and ready for setting limits
Check motor direction Setting Limits**

ADJUSTING LIMITS

Adjust upper limit 5.2 Adjust lower limit

ADDING OR REMOVING CONTROLLERS AND CHANNELS

Using motor P1 button Using a pre-existing controller

A= Exisiting controller or channel (to keep] B= Controller or channel to add or remove IMPORTANT
Consult user manual for your controller or sensor.

FAVORITE POSITIONING

Set favorite position
Move shade to the desired position by pressing the UP or DOWN button on the controller. Send shade to favorite position Delete favorite position![OTTO Wired 6 Motorized Roller Shades

• Delete favorite position](https://manuals.plus/wp-content/uploads/2024/03 /OTTO-Wired-6-Motorized-Roller-Shades-Delete-favorite-position.png)

ROLLER MODE

Enter roller mode (Default)

SLEEP MODE

Enter Sleep Mode
Sleep mode is utilized to prevent a motor from moving during shipping of a fabricated shade
Hold P1 button on the motor head Exit Sleep Mode
Exit sleep mode once the shade is installed
Press and release P1 button on the motor head

TROUBLESHOOTING

power cable connection and AC plug.
Battery in wand are depleted| Replace 8xAA alkaline batteries.
Power failure| Check power supply to motor is connected and active
Transmitter battery is discharged| Replace battery
Battery is inserted incorrectly into transmitter| Check battery polarity
Radio interference/shielding| Ensure transmitter is positioned away from metal objects and the aerial on motor or receiver is kept straight and away from metal
Receiver distance is too far from transmitter| Move transmitter to a closer position
Incorrect wiring| Check that wiring is connected correctly (refer to motor installation instructions)
Unable to adjust or set limits.| Remote is in a locked state.| Change remote status to an unlocked state
Cannot program a single Motor (multiple motors respond)| Multiple motors are paired to the same channel.| Always reserve an individual channel for programming functions
SYSTEM BEST PRACTICE – Provide an extra 15 channel remote in your multi motor projects, that provides individual control for each motor for programming purposes
Place all other motors into sleep mode.

WARNING
Cords on window covering products present a potential strangulation hazard.
For child safety, consider cordless alternatives or products with inaccessible cords.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>