Fronius OPT-i Wire Actual Value Transmitter Instruction Manual

Fronius OPT-i Wire Actual Value Transmitter

General

Safety

WARNING!
Danger from incorrect operation and work that is not carried out properly. This can result in serious personal injury and damage to property.

• All the work and functions described in this document must only be carried out by technically trained and qualified personnel.
• Read and understand this document in full.
• Read and understand all safety rules and user documentation for this equip-ment and all system components.

WARNING!

Danger from electrical current.
This can result in serious personal injury and damage to property.

• Before starting work, switch off all devices and components involved, and disconnect them from the grid.
• Secure all devices and components involved so they cannot be switched back on.
• After opening the device, use a suitable measuring instrument to check that electrically charged components (such as capacitors) have been discharged.

Scope of supply

1. Wire infeed tube
2. Rubber bushing
3. Sensor with cable
4. Inlet piece
   Not shown:
   these Installation Instructions

Installing the OPT/i wire actual value transmitter

Preparation

1. Switch off the power source and disconnect from the grid

2. Disconnect the CWF 25i R wirefeeder from all system components

3. Open side panel

4. Remove the 5 TX20 screws

5. Remove lid with side panel

6. Remove the 2 TX20 screws

7. Pull off the cover to the front

8. Remove the dummy cover

9. Remove 2 TX25 screws
   The screws will be required for subsequent work steps.

10. Remove existing wire infeed tube

11. Unscrew the infeed tube nozzle from the previously removed wire infeed tu-be

12. Screw the infeed tube nozzle onto the inlet piece included in the scope of supply

Installing the OPT/i wire actual value transmit-ter

1. Guide the sensor cable through the opening in accordance with the illustration

2. Insert the rubber bushing into the opening

3. Route the sensor cable through the device to the opposite sideIMPORTANT! When plugging in the sensor cable, make sure that the clamping nose of the plug points towards the center of the PCB inside the device.

4. Connect sensor cable on PCB SR63 to X13, e.g. with the aid of needle-nose pliers

5. Fit cover

6. Secure the cover using 2 TX 20 screws Tightening torque = 2 Nm

7. Insert the inlet piece into the motor plate using needle-nose pliers

8. Insert sensor and hold from the front

9. Insert the wire infeed tube included in the scope of supply

10. Secure the wire infeed tube using 2 TX20 screws Tightening torque = 3.5 Nm

Final tasks

1. Put on lid with side panel
2. Secure lid using 5 TX20 screws Tightening torque = 2 Nm
3. Close the side panel

Fronius International GmbH
FroniusstraBe 1
4643 Pettenbach
Austria

contact@fronius.com
www.fronius.com

Under www.fronius.com/contact you will find the addresses of all Fronius Sales & Service Partners and Locations.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>