LED WORLD LIGHTING QS-107T-2.2W-12V 2.2W LED Puck Light Recessed/Surface Mount Instructions
- June 9, 2024
- LED WORLD LIGHTING
Table of Contents
ledworldlighting.com
ledworld.ca
1-800-387-4081
LED PUCK LIGHT (Recessed/Surface Mounted)
Model : QS-107T-2.2W-12V-X
IMPORTANT INSTRUCTIONS
CAUTION: To reduce the risk of electric shock:
- Use only insulated staples or plastic ties to secure cords.
- Route the low voltage wire from the light so that they will not be damaged or pinched when the cabinet is installed (pushed to the wall).
- Not intended for recessed ceiling installation or softs.
Low voltage portable cabinet light maybe installed in furniture or cabinets when:
- The power supply is located outside cabinets and is not concealed (this does not apply to the wiring between the light and the power supply).
- When the low voltage wire are not concealed or pass through the structure of the building (concealed behind the wall) where it may be inaccessible for examination or where damage to may go unnoticed.
- Cords should be visible and examined regularly.
Installation instructions:
- Must be installed by a qualified licenced electrician.
- Turn power off prior to installation.
- Bore a hole Ø2.16″ (55mm) minimum recess depth required 0.17″ (4.5mm).
- Route the low voltage wiring through the hole.
- Insert the light into the hole; fiction t light will lock in place.
- Connect the light’s low voltage wiring into the class 2 LED power supply. (#MD-012-060VTDHV2, #MD-012-030VTDHV2 – sold separately).
WARNING: Use only with Class 2 Power Supply. Always connect the LED light to the power supply first and then connect the power supply to the mains. Failure to do so may cause damage to the existing diode.
THREE YEAR LIMITED LIGHTING WARRANTY
LED WORLD INC. warranties this product for three year (some exceptions may
apply) from the date of shipping unless otherwise noted in writing. This
warranty is expressly in lieu of all other warranties expressed or implied.
Under this Limited Warranty, the obligation of the company is limited to
replacing on a prorated basis, at its option, any component found to be
defective. This Limited Warranty does not apply to damage caused by buyer or
alteration to the product or incorrect power supply. Factory warrantees are
covered by the original manufacturer and claims must be submitted to them.
LED World Inc. And its providers will never be liable to you or any other
person for any indirect, incidental, consequential, special, punitive or
exemplary loss or damage arising from, connected with, the purchase of
products, including but not limited to loss of data, business, markets, cost
of labour, savings, income, profits, use, production, reputation or goodwill,
anticipated or otherwise, or economic loss, under any theory of liability
(whether in contract, tort, strict liability or any other theory or law or
equity), regardless of any negligence or other fault or wrongdoing (including
without limitation gross negligence and fundamental breach) by led world inc.
Or any person for whom led world inc. Is responsible, and even if led world
inc. Has been advised of the possibility of such loss or damage being
incurred.
If a product is defective, we will replace the product with similar or
identical product or at our option a credit towards a future purchase. To make
a claim under this warranty, obtain a return authorization number.
For Under Cabinet lighting and Under Counter Top Lighting
RECESSED MOUNTING:
- Turn off the power at breaker
- Drill a Ø55mm hole through cabinet or shelf, see fig 1.
- Connect light to the Class 2 driver, see fig 2.
- Insert the recessed puck light into the cut hole and mount with screws, see fig 1a.
- Turn on the power.
SURFACE MOUNTING:
- Turn off the power at breaker.
- Take the surface mounting ring off the fitting, see fig 1b.
- Mount the ring to surface with the attached screws, pay attention to the direction of the notch for the cord, see g 1b.
- Connect light to the Class 2 driver, see fig 2.
- Attach the recessed puck light back into the surface mount ring, see fig 1b.
- Turn on the power.
LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA |
Version 1.0 – 11/29/22
Copyright © 2022 LED WORLD INC™. All Rights Reserved. We are not responsible
for errors or omissions. Product and specifications subject to change without
notice. Registered trademarks are owned by their respective registers, or
licensee(s).
References
- LED World Canada - A Commercial LED lighting supplier
- LED World Lighting - A Commercial LED lighting supplier