Signature Hardware 939234 Vanity Light User Guide
- June 8, 2024
- Signature Hardware
Table of Contents
Signature Hardware 939234 Vanity Light
GETTING STARTED
Ensure that you have gathered all the required materials that are needed for the installation
BEFORE YOU BEGIN
We recommend consulting a professional if you are unfamiliar with installing electric fixtures. Signature Hardware accepts no liability for any damage to the faucet, plumbing, sink, counter top, or for personal injury during installation. Observe all local plumbing and building codes. Unpack and inspect the product for shipping damage. If any damage is found, contact our Customer Relations team via live chat at www.signaturehardware. com or by emailing support@siganturehardware.com
FOR YOUR SAFETY
Be sure the electricity to the wires you are working on is shut off, either the fuse is removed or the circuit breaker is shut off. You do not need special tools to install this fixture. Be sure to follow the steps in the order given. Under no circumstances should a fixture be hung on house electrical wires, nor should a swag-type fixture be installed on a ceiling that contains a radiant-type heating system. Read instructions carefully. If you are unclear as to how to proceed, consult a qualified electrician.
CARE INSTRUCTIONS
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap. Do not use abrasive materials such as scouring pads or powders, steel wool or abrasive paper.
TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION (not included)
SAVE THIS MANUAL
RETAIN FOR CONSUMER USE. READ THESE INSTRUCTIONS COMPLETELY BEFORE INSTALLING THE PRODUCT: FOR PRODUCT OR INSTALLATION QUESTIONS PLEASE CALL CUSTOMER SERVICE AT 1-800-221-3379.
INSTALLATION
- Remove mounting plate (B) from fixture back plate (F) by removing the flat head screws (D)
- Connect positive supply wire in black to positive fixture lead with connector. Connect negative supply wire in white to negative fixture lead. Connect the ground wire (green or bare copper) with fixture’s ground wire with connector. Tuck the wire connections neatly into the junction box.
- Slide the wires from the junction box (A), through the center hole, make sure curved slots on the mounting plate (B) line up with threaded holes (E) in the junction box(A).
- Use two screws (C) to attach the mounting plate (B) to the junction box (A).
- Mount the fixture by sliding the back plate (F).
- Attach the back plate (F) to the mounting plate using the flat head screws (D).
VANITY LIGHT
- To install glass (3), slip small hole in bottom of glass over the socket (4)
- Thread socket ring (2) onto socket (4) and tighten to secure glass (3).
- Install the light bulbs (1); not included, in the sockets (4).
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>