HYUNDAI 68751 Workshop Stove 3000 W User Manual
- June 8, 2024
- HYUNDAI
Table of Contents
HYUNDAI 68751 Workshop Stove 3000 W
WORKSHOP HEATER 3000 W 68751
WARNING
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may result in electric shock,
fire and/or serious injury. Save all warnings and instructions for future
reference.
The following symbols are used throughout this manual:
- Denotes risk of personal injury or damage to the machine.
- Important information about the use of the machine.
SAFETY WARNINGS
Always follow the safety instructions below carefully when using the device.
- Do not use the appliance if the cord or plug is damaged, or if there are visible signs of damage.
- Keep the device and cord away from heat sources, sharp objects or anything that can cause damage.
- Have a defective device repaired only by an authorized service company.
- Indoor use only.
- Do not use this appliance if it has been dropped or if water has entered it.
- NEVER use this device where it may come into direct contact with water.
- Always make sure hands are dry before operating or adjusting any switch on the product or touching the plug and outlet.
- Do not insert objects of any kind into the ventilation or exhaust openings, and do not allow foreign objects to enter the ventilation or exhaust openings (danger of electric shock, fire or damage to the device). These openings should also not be covered or blocked.
- Due to the risk of fire, place the device at least 1 m away from combustible materials such as curtains, furniture, cushions, bedding, paper, clothing, etc.
- Do not use the appliance in dusty areas due to the risk of fire.
- Keep the power cord away from the hot case of the device.
- Some parts of this product can become very hot; the appliance remains warm for a while after it is turned off. Do not touch the hot surfaces.
- Always place the appliance on a horizontal and stable surface.
- Do not place the device in front of or directly below an electrical outlet.
- Do not place the power cord in a crowded area to prevent people from tripping over it.
- Only use a suitable extension cord.
- Do not connect other appliances to the same outlet as this heater.
- Do not use timers to switch the device on or off automatically.
- Do not use the device in areas where gasoline, paint or other flammable liquids are used or stored.
- Do not leave the device unattended for a long time during use.
- Do not use the device in rooms with a volume smaller than 15 m
- This appliance can be used by children aged 8 years and older and by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, provided they are given supervision or instruction regarding the safe use of the appliance and understand the dangers.
- Children should always be closely supervised when they are around electrical appliances. Do not let children play with the appliance.
Do not cover. NEVER use the appliance to dry clothing or similar items.
ELECTRICAL SAFETY
Check that the voltage stated on the rating plate of the appliance corresponds
to the locally available mains voltage.
Only connect the device to an earthed wall socket.
DESCRIPTION (FIG. A)
This appliance provides pleasant heat when additional heating is required.
- On/off indicator light
- Selector switch
- Thermostat knob
- Handle
Package contents
- Workshop heater
- Instruction manual
- Warranty and service conditions
OPERATION
-
Connect the device to an earthed socket.
-
Set the thermostat knob (3) to the maximum position and let the appliance operate at full power.
-
The appliance is switched on when the heating selector switch (2) is set to one of the power levels. The on/off indicator light (1) lights up.
-
When the room has reached the desired temperature, the heating element will stop working while the fan continues to work.
-
Once the temperature has dropped, the heating will turn on again.
The heating starts and stops automatically and thus keeps the room temperature constant. -
Before switching off the appliance, turn the thermostat knob (3) to the minimum position and set the selector switch (2) to the fan position.
-
Let the device cool down for two minutes, switch off the device and pull the plug from the socket.
Overheating protection
The device has a built-in thermostat and a self-resetting thermal protection to control the heating elements. The thermostat measures and regulates the temperature. The fan is controlled by the thermostat and stops when the thermostat turns off the heating element. The thermal protection switches off the heater in case of overheating to ensure safety.
CLEANING
Regular cleaning extends the life of the device.
- Clean the housing with a soft cloth or soft paper. If dirt is difficult to remove, use a soft cloth with a little soapy water.
- Use a vacuum cleaner to vacuum dust and lint from the grille.
- Never try to clean the inside of the heater.
- Store the device in a cool, dry place.
Do not use chemical cleaners, gasoline or other solvents.
These can irreparably damage the housing.
Always remove the plug from the socket and let the heater cool down completely before cleaning or performing maintenance.
TECHNICAL DATA
- Mains voltage Vac 220-240
- Mains frequency Hz 50
- Power input W 3000
- Settings W 25-1500-3000
- Fuse A 16
- Splash-proof IP20
- Weight kg 2.85
GUARANTEE
Refer to the enclosed guarantee conditions for the terms and conditions of
guarantee.
Troubleshooting
If you experience any problems, please refer to the table below.
| Problem | Possible causes | Solution |
|---|
The heater does not work even when the plug is in the socket and the switch and thermostat are turned on.|
- The plug is loose or not seated properly.
- No voltage at the socket.
|
- Unplug the plug and check the connection of the plug and socket. Then reconnect the plug to the socket.
- Plug the power cord into a working outlet.
The heating element glows.|
- The voltage is too high or too low.
- The air inlet grille is blocked.
|
- Connect the appliance to a mains socket whose voltage corresponds to the value indicated on the rating plate.
- Keep the appliance away from items that could cover the inlet, such as curtains, plastic bags and paper.
The appliance does not heat up, only the fan works.|
- The switch is not in the heating position.
- The thermostat is not turned on.
- The thermal protection is enabled.
|
- Set the switch to the heating position.
- Turn the thermostat and listen for an on/off click. If there is no click and the thermostat is not damaged, the heater will switch on automatically when the appliance has cooled down.
- Switch off the appliance and inspect the blockage of the inlet or outlet. Unplug the power cord and wait at least 10 minutes for the protection to reset before attempting to restart the device.
The device makes a strange noise.|
- The device is not upright.
|
- Place the device upright on a flat surface.
ENVIRONMENT
Your product, accessories and packaging should be sorted for environmental-
friendly recycling.
Only for EC countries
Do not dispose of power tools into domestic waste. According to the European
Guideline 2002/96/EC for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that are no longer usable must
be collected separately and disposed of in an environmentally friendly way.
Subject to change; specifications can be changed without further notice.
**DECLARATION OF CONFORMITY
**
ART. NR. HYUNDAI 68751 TYPE NR. BGP1506-03
Workshop heater
Dvize bv declares under its sole responsibility that this product is in
conformity with the following standards or standardization documents:
- EN 55014-1:2017+A11,
- EN 55014-2:2-15,
- EN IEC 61000-3-2:2019,
- EN 61000-3-3:2013+A1
According to the provisions of the directives:
2014/30/EU
LGA Products GmbH –
Keeper of the technical documentation:
A.N.P van Oort
Directeur
01-01-2021
Dvize bv
Witte Vlinderweg 51,1521 PS Wormerveer, Nederland
info@dvize.eu, www.hyundai-air-nl.com
Dvize bv
Witte Vlinderweg 51 1521 PS Wormerveer
info@dvize.eu Nederland
www.hyundai-air-nl.com
Licensed by Hyundai Corporation Holdings, Korea
Imported/Distributed by Dvize bv, The Netherlands
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>