Signature Hardware 440636 Stonehouse 3-Light 25.4-in Smooth Bronze Outdoor Wall Light Instruction Manual
- June 8, 2024
- Signature Hardware
Table of Contents
Signature Hardware 440636 Stonehouse 3-Light 25.4-in Smooth Bronze
Outdoor Wall Light
BEFORE YOU BEGIN
We recommend consulting a professional if you are unfamiliar with installing
electric fixtures. Signature Hardware accepts no liability for any damage to
the faucet, plumbing, sink, counter top, or for personal injury during
installation.
Observe all local plumbing and building codes. Unpack and inspect the product
for shipping damage. If any damage is found, contact our Customer Relations
team via live chat at www.signaturehard-ware.com or by emailing support@siganturehard-ware.com.
GETTING STARTED
Ensure that you have gathered all the required materials that are needed for the installation.
FOR YOUR SAFETY
WARNING: Be sure the electricity to the wires you are working on is shut off, either the fuse is removed or the circuit breaker is shut off. You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Under no circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be installed on a ceiling which contains a radiant type heating system. Read instructions carefully, if you are unclear as to how to proceed, consult a qualified electrician.
OUTDOOR HANGING PENDANT
CARE AND MAINTENANCE:
To clean, wipe with damp cloth. Do not use abrasive cleaners or cleaners
that contain alcohol.
CAUTION:
Shut off main power supply before cleaning product or changing light bulbs.
All glass is fragile. Use care when handling glass shades and bulbs.
RECOMMENDED TOOLS AND ACCESSORIES
SAVE THIS MANUAL: RETAIN FOR CONSUMER’S USE. READ THESE INSTRUCTIONS COMPLETELY BEFORE INSTALLING THE PRODUCT: FOR PRODUCT OR INSTALLATIO QUESTIONS PLEASE CALL CUSTOMER. SERVICE AT 1‐800‐221‐3379.
INSTALLATION
- Shut off the power at the circuit breaker and remove old fixture, including the crossbar.
- Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
- Attach the cross bar (B) to the outlet box (A) (not supplied) using the 2 screws provided with the outlet box (A).
- CONNECTING THE WIRES Now connect the electrical wires as follows: Connect the smooth wire from the fixture to the black or red (lead) supply wire. Connect the ridged wire from the fixture to the white (neutral) supply wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect fixture’s ground wire to it. Otherwise, connect fixture’s ground wire directly to the crossbar using the green screw provided. Tuck the wire connections neatly into the ceiling junction box.
- Connect the screw collar L oop (D) with the chain (J ) by the quicks link (N) .
- Move up the canopy (E) to the ceiling and secured by the screw collar ring (F) to the screw sollar loop (D).
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>