Signature Hardware 440637 Cedar Manor Outdoor Hanging Pendant Light Instruction Manual
- June 8, 2024
- Signature Hardware
Table of Contents
440637 Cedar Manor Outdoor Hanging Pendant Light
Instruction Manual
440637 Cedar Manor Outdoor Hanging Pendant Light
BEFORE YOU BEGIN
We recommend consulting a professional if you are unfamiliar with installing
electric fixtures. Signature
Hardware accepts no liability for any damage to the faucet, plumbing, sink,
counter top, or for personal injury during installation.
Observe all local plumbing and building codes.
Unpack and inspect the product for shipping damage.
If any damage is found, contact our Customer
Relations team via live chat at
www.signaturehardware.com or by
emailing
support@siganturehardware.com.
GETTING STARTED
Ensure that you have gathered all the required materials that are needed for
the installation.
FOR YOUR SAFETY
WARNING: Be sure the electricity to the wires you are working on is shut
off, either the fuse is removed or the circuit breaker is shut off. You don’t
need special tools to install this fixture. Be sure to follow the steps in the
order given. Under no circumstances should a fixture be hung on house
electrical wires, nor should a swag type fixture be installed on a ceiling
which contains a radiant type heating system. Read instructions carefully, if
you are unclear as to how to proceed, consult a qualified electrician.
TOOLS AND MATERIALS:
| Wire Connector
---|---
| Mounting Hardware
| Canopy
| Screw
| Cap Nuts (2pcs)
INSTALLATION
- Shut off the power at the circuit breaker and remove old fixture, including the crossbar.
- Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
Connect Black or Red
Supply Wire (Lead Wire) to:| Connect White Supply
Wire (Neutral Wire) to:
---|---
Black wire| White wire
Parallel wire (round or smooth)| Parallel wire
(square or ridged)
Clear, brown, gold or black wire without tracer| Clear, brown, gold or black wire with tracer
Insulated wire (other than green) with copper conductor| Insulated wire (other than green) with silver conductor
-
When parallel wires are used, the neutral wire is ridged down its length and the other wire is round and smooth (see illus.).
3. Attach the cross bar (B) to the outlet box (A) (not supplied) using the 2 screws provided with the outlet box (A). 4. CONNECTING THE WIRES
Now connect the electrical wires as follows: Connect the smooth wire from the fixture to the black or red (lead) supply wire. Connect the ridged wire from the fixture to the white (neutral) supply wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect fixture’s ground wire to it. Otherwise, connect fixture’s ground wire directly to the crossbar using the green screw provided. Tuck the wire connections neatly into the ceiling junction box.- Connect the deroated tube (H) to the roof (M) by screws (J).
- Connect the canopy (E) and roof (M) by the stem (K).
- Move up the canopy (E) to the ceiling and secured by the mounting screws (D).
1.855.715.1800
signaturehardware.com
Documents / Resources
|
Signature Hardware 440637 Cedar Manor Outdoor Hanging Pendant
Light
[pdf] Instruction Manual
440637, Cedar Manor, Outdoor Hanging Pendant Light, Cedar Manor Outdoor
Hanging Pendant Light, 440637 Cedar Manor Outdoor Hanging Pendant Light,
Hanging Pendant Light, Pendant Light, Light
---|---