SIGNATURE HARDWARE 949639 Blackthorne Industrial Dome Pendant Light Instruction Manual

: June 8, 2024
: Signature Hardware

Table of Contents

BEFORE YOU BEGIN
GETTING STARTED
ADDITIONAL QUESTIONS?
FOR YOUR SAFETY
CARE INSTRUCTIONS
TOOLS AND MATERIALS:
INSTALLATION (FIG 1)
INSTALLATION (FIG 2)
CUSTOMER SUPPORT
Documents / Resources

SIGNATURE HARDWARE 949639 Blackthorne Industrial Dome Pendant Light

949639 Blackthorne Industrial Dome Pendant Light

BEFORE YOU BEGIN

We recommend consulting a professional if you are unfamiliar with installing electric fixtures. Signature Hardware accepts no liability for any damage to the faucet, plumbing, sink, counter top, or for personal injury during installation.
Observe all local plumbing and building codes.
Unpack and inspect the product for shipping damage.
If any damage is found, contact our Customer
Relations team via live chat at www.signaturehardware.com or by emailing support@siganturehardware.com.

GETTING STARTED

Ensure that you have gathered all the required materials that are needed for the installation.

ADDITIONAL QUESTIONS?

Still need help? Check out our Help Center at www.signaturehardware.com for product and warranty information, or contact us through live chat or by emailing support@signaturehardware.com.

FOR YOUR SAFETY

For Your Safety

WARNING: Be sure the electricity to the wires you are working on is shut off, either the fuse is removed or the circuit breaker is shut off. You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Under no circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be installed on a ceiling which contains a radiant type heating system. Read instructions carefully. If you are unclear as to how to proceed, consult a qualified electrician.

CARE INSTRUCTIONS

To clean, wipe fixture with a soft cloth. Clean glass with a mild soap. Do not use abrasive materials such as scouring pads or powders, steel wool or abrasive paper

TOOLS AND MATERIALS:

**Safety goggle

**

**Step ladder

**

**Wire strippers

**

**Wire cutters

**

**Phillips screwdriver

**

**Flathead screwdriver

**

**Electrical tape

**

**Light Bulb (G40 60 watt maximum)

**

SAVE THIS MANUAL: RETAIN FOR CONSUMER’S USE.

INSTALLATION (FIG 1)

$Installation $Fig 1$$

Loosen the screw (F) adjust to the desired height of braid wire (G), then secure it with screw (F).

INSTALLATION (FIG 2)

Thread the mounting screws (A) into the matching holes in the mounting bar (B).
Secure mounting bar (B) to the outlet box with outlet box screws (C).
Connect the white wire from the fixture to the white wire from the outlet box and the black wire from the fixture to the black wire from the outlet box. Cover the two wire connections using the two provided wire connectors. Wrap the two wire connections with electrical tape for a more secure connection. Attach the grounding wire connections with electrical tape for a more secure connection. Connect the copper ground wires from the fixture and from the outlet box to the ground screw on the mounting bar.
Note: If you have electrical questions, consult your local electrical code for approved grounding methods.
Remarque: Pour touted question concernantle
After wires are connected, tuck them carefully inside outlet box. Raise the canopy (D) allowing for the mounting screws (A) to protrude through the holes on canopy (D), and secure with the ball nuts (E).
Install light bulb (Not provided). Please do not exceed the maximum wattage capacity recommended on the socket.

CUSTOMER SUPPORT

1.855.715.1800
signaturehardware.com

SIGNATURE HARDWARE-Logo

Documents / Resources

| SIGNATURE HARDWARE 949639 Blackthorne Industrial Dome Pendant Light [pdf] Instruction Manual
949639, Blackthorne Industrial Dome Pendant Light, Industrial Dome Pendant Light, Blackthorne Pendant Light, Pendant Light, Light
---|---