Signature Hardware 440494 Odell Pendant Light Single Light Instruction Manual

: June 8, 2024
: Signature Hardware

Table of Contents

BEFORE YOU BEGIN
GETTING STARTED
ADDITIONAL QUESTIONS?
FOR YOUR SAFETY
TOOLS AND MATERIALS
INSTALLATION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

**Signature Hardware 440494 Odell Pendant Light Single Light

**

BEFORE YOU BEGIN

We recommend consulting a professional if you are unfamiliar with installing electric fixtures. Signature Hardware accepts no liability for any damage to the faucet, plumbing, sink, counter top, or for personal injury during installation.
Observe all local plumbing and building codes.
Unpack and inspect the product for shipping damage.
If any damage is found, contact our Customer Relations team via live chat at www.signaturehardware.com or by emailing support@siganturehardware.com.

GETTING STARTED

Ensure that you have gathered all the required materials that are needed for the installation.

ADDITIONAL QUESTIONS?

Still need help? Check out our Help Center at www.signaturehardware.com for product and warranty information, or contact us through live chat or by emailing support@signaturehardware.com.

FOR YOUR SAFETY

WARNING: Be sure the electricity to the wires you are working on is shut off, either the fuse is removed or the circuit breaker is shut off. You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Under no circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be installed on a ceiling which contains a radiant type heating system. Read instructions carefully, if you are unclear as to how to proceed, consult a qualified electrician.

TOOLS AND MATERIALS

Light Bulb (60 watt maximum)
Safety Glasses
Wire Stripper
Step Ladder
Phillips Screwdriver
Flathead Screwdriver
Wire Cutters
Electrical Tape

INSTALLATION

Thread the mounting screws (A) into the matching holes in the circular strap (B).
Secure circular strap (B) to the outlet box with outlet box screws (C).
Connect the white wire from the fixture to the white wire from the outlet box and the black wire from the fixture to the black wire from the outlet box. Cover the two wire connections using the two provided wire connectors. Wrap the two wire connections with electrical tape for a more secure connection. Connect the copper ground wires from the fixture and from the outlet box to the ground screw on the circular strap.
Note: If you have electrical questions consult your local electrical code for approved grounding methods.
After wires are connected, tuck them carefully inside outlet box. Raise the front plate (D) allowing for the mounting screws (A) to protrude through the holes on front plate (D), and secure with the ball nuts (E).
Assemble the tube (H) and (G) together, then thread the bottom end of tube (H) into the coupling (I) tightly, thread the top end of the tube (G) onto the nipple (F) tightly.
Assemble the decorative frame (L) over the socket (K) and secure with socket ring (M).
Put the glass shade (M) over the socket (L) and secure with thumb screw (K) . Install light bulb (included). Please do not exceed the maximum wattage capacity recommended on the socket (K).
We recommend the use of a clear light bulb.