Signature Hardware 944702 Hillpoint 6 Light 48 Inch Wide Linear Instruction Manual

Signature Hardware 944702 Hillpoint 6 Light 48 Inch Wide Linear

BEFORE YOU BEGIN

• We recommend consulting a professional if you are unfamiliar with installing electric fixtures. Signature
• Hardware accepts no liability for any damage to the faucet, plumbing, sink, counter top, or for personal injury during installation.
• Observe all local plumbing and building codes.
• Unpack and inspect the product for shipping damage.
• If any damage is found, contact our Customer
• Relations team via live chat at www.signaturehardware.com or by emailing support@siganturehardware.com.

GETTING STARTED

Ensure that you have gathered all the required materials that are needed for the installation.

ADDITIONAL QUESTIONS

Still need help? Check out our Help Center at www.signaturehardware.com for product and warranty information, or contact us through live chat or by emailing support@signaturehardware.com.

FOR YOUR SAFETY

WARNING: Be sure the electricity to the wires you are working on is shut off, either the fuse is removed or the circuit breaker is shut off. You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Under no circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be installed on a ceiling which contains a radiant type heating system. Read instructions carefully, if you are unclear as to how to proceed, consult a qualified electrician.

TOOLS AND MATERIALS

INSTALLATION

1. Thread the loop (J) onto the nipple (K).

2. Install light bulbs (Not provided). Please do not exceed the maximum wattage capacity recommended on the socket.

3. Placet he cap( M) onto the candle sleeve (L).

4. Position the back plate (B) through the fixing holes onto the ceiling and make marks, drill pilot holes for wood screws (C) into the ceiling, then insert the plastic anchor (A) into the holes.

5. Secure the back plate (B) to outlet box with the outlet box screws (F), then secure the wood screw (E) into plastic anchor (A) in the ceiling. Open one link of chain (I), connect it to fixture loop (J). Open the other one link of chain (I), connect it to loop (H) and close the link. BE SURE TO CLOSE ALL CHAIN LINKS COMPLETELY.

6. Lace wires up through chain (I) and pass wires through holes in loop (H). We recommend lacing wire up through every other link of chain (I).

7. Please note: The ribbed wire will be a neutral wire, and the smooth wire will be a lead wire. The smooth wire will also have a printed temperature warning. Read instructions carefully. If you are unclear as to how to proceed, consult a qualified electrician.

8. Connect he white wire from the outlet box to the neutral wire (ribbed) from the fixture and the black wire from the outlet box to the lead wire (smooth) from the fixture. Cover the two wire connections using the two provided wire connectors. Wrap the two wire connections with electrical tape for a more secure connection. Connec the copper ground wires from the fixture and from the outlet box to the ground screw on the mounting.
   Note: If you have electrical questions, consult your local electrical code for approved grounding methods.

9. After wires are connected, tuck them carefully inside outlet box. Raise the canopy (F) allowing for the mounting.

References

• ware
• Signature Hardware - Shop Unique, Quality Decor

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>