SIGNATURE HARDWARE Centerville 944745, 944751 Vanity Light Instruction Manual
- June 8, 2024
- Signature Hardware
Table of Contents
SIGNATURE HARDWARE Centerville 944745, 944751 Vanity Light
BEFORE YOU BEGIN
We recommend consulting a professional if you are unfamiliar with installing
electric fixtures. Signature Hardware accepts no liability for any damage to
the faucet, plumbing, sink, counter top, or for personal injury during
installation.
Observe all local plumbing and building codes. Unpack and inspect the product
for shipping damage. If any damage is found, contact our Customer Relations
team via live chat at www.signaturehard-ware.com or by emailing support@siganturehard-ware.com.
GETTING STARTED
Ensure that you have gathered all the required materials that are needed for the installation.
ADDITIONAL QUESTIONS?
Still need help? Check out our Help Center at www.signaturehardware.com for product and warranty information, or contact us through live chat or by emailing support@signaturehard-ware.com.
FOR YOUR SAFETY
WARNING:
- Be sure the electricity to the wires you are working on is shut off, either the fuse is removed or the circuit breaker is shut off.
- You don’t need special tools to install this fixture.
- Be sure to follow the steps in the order given.
- Under no circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be installed on a ceiling which contains a radiant type heating system.
- Read instructions carefully, if you are unclear as to how to proceed, consult a qualified electrician.
TOOLS AND MATERIALS:
- Light Bulb (A19 100 watt maximum)
- Wire Stripper
- Phillips Screwdriver
- Wire Cutters
- Safety Glasses
- Step Ladder
- Flathead Screwdriver
- Electrical Tape
INSTALLATION
-
Secure circular strap (B) to the outlet box with outlet box screws (A).
-
Connect the white wire from the fixture to the white wire from the outlet box and the black wire from the fixture to the black wire from the outlet box. Cover the two wire connections using the two provided wire connectors. Wrap the two wire connections with electrical tape for a more secure connection. Attach the grounding wire connections with electrical tape for a more secure connection. Connect he copper ground wires from the fixture and from the outlet box to the ground screw on the mounting bar.
Note: If you have electrical questions, consult your local electrical code for approved grounding methods. -
After wires are connected, tuck them carefully inside outlet box. Raise the front plate (D) and put it over the circular strap (B) with thumb screws (C) well.
-
Place the glass shade (F) over the socket (E) in order, then secure with socket ring (G).
-
Install light bulbs (not provided).
Please do not exceed the maximum wattage capacity recommended on the socket (F). We recommend the use of a clear light bulb.