Signature Hardware 944721 Edgehill Outdoor Wall Sconce Light Instruction Manual
- June 8, 2024
- Signature Hardware
Table of Contents
944721 Edgehill Outdoor Wall Sconce Light
Instruction Manual
944721 Edgehill Outdoor Wall Sconce Light
BEFORE YOU BEGIN
We recommend consulting a professional if you are unfamiliar with installing
electric fixtures. Signature Hardware accepts no liability for any damage to
the faucet, plumbing, sink, counter top, or for personal injury during
installation.
Observe all local plumbing and building codes. Unpack and inspect the product
for shipping damage. If any damage is found, contact our Customer
Relations team via live chat at
www.signaturehardware.com or by emailing
support@siganturehardware.com.
GETTING STARTED
Ensure that you have gathered all the required materials that are needed
for the installation.
FOR YOUR SAFETY
WARNING: Be sure the electricity to the wires you are working on is shut
of, either the fuse is removed or the circuit breaker is shut of. You don’t
need special tools to install this fixture. Be sure to follow the steps in the
order given. Under no circumstances should a fixture be hung on house
electrical wires, nor should a swag type fixture be installed on a ceiling
which contains a radiant type heating system. Read instructions carefully, if
you are unclear as to how to proceed, consult a qualified electrician.
TOOLS AND MATERIALS:
INSTALLATION
- Shut of the power at the circuit breaker and remove old fixture, including the crossbar.
- Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
- Thread the 2 Mounting Screws (C) to the Mounting plate (E). (You can adjust the length of the screws if necessary.)
- Attach the Mounting plate(E)to the Outlet Box (G) (not supplied) by using 2 Outlet Box Screws (B).
- Now connect the electrical wires as follows:Connect the black wire from the fixture to the black house (hot) wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect fixture’s ground wire to it. Otherwise, connect fixture’s ground wire directly to the mounting plate using the green screw provided. Tuck the wire connections neatly into the junction box.
- Attach the Fixture (H) to the Mounting Plate by inserting the 2 Mounting Screws (C),and then secure with the 2 Cap Nuts (F).
- To prevent moisture from entering the outlet box and causing a short, use clear caulking(ie. Indoor/Outdoor Silicone Sealant) to outline the outside of fixture backplate where it meets the wall leaving a space at bottom to allow moisture a means to escape.
1.855.715.1800
Signaturehardware.com