Netatmo QSG-HCP Smart Indoor Air Quality Monitor User Manual
- June 8, 2024
- Netatmo
Table of Contents
Netatmo QSG-HCP Smart Indoor Air Quality Monitor
Use the micro-USB
Use the micro-USB power adapter provided with the Smart Indoor Air Quality Monitor.
Smart Indoor Air Quality
Keep the Smart Indoor Air Quality Monitor away from direct sunlight or heat sources.
bottom part
Screw the bottom part of the mount to the wall using the black screws and the anchors.
Remove the bottom cover
optional: Remove the bottom cover from the product and use three metal screws to secure the product to the top part of the mount.
cable roll it inside
Pass the cable through the hole and secure it with the fastener. Then roll it inside the mount.
micro-USB plug
Connect the micro-USB plug and clip the top part of the mount to the bottompart. You can secure it with the fourth metal screw.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reaso- an ble protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. lf this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Should you need further certification information (FCC ID, IC) please open the cover at the bottom of the product by rotating it counterclockwise with the palm of your hand.
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body and must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Caution!
Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
References
- Building
- netatmo.com/declaration/nhc
- netatmo.com/declaration/nhc
- Building
- Netatmo : same home, just smarter
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>