MANIA 208LED Solar Sensor Light Motions Detections Instructions

: June 6, 2024
: MANIA

Table of Contents

PACKAGE CONTENTS
TECHNICAL SPECIFICATIONS
INSTALLATION
HOW TO USE
WARNINGS
WARRANTY
WEEE disposal and recycling symbol
Read User Manual Online (PDF format)
Download This Manual (PDF format)

MANIA 208LED Solar Sensor Light Motions Detections Instructions

PACKAGE CONTENTS

Solsense light
Light mount
3 screws and plastic plugs
User’s manual

TECHNICAL SPECIFICATIONS

Illuminated area: 50–80 m²
IP rating: IP65
Solar panel: 5 V, 300 mA
Output power: 4 W
Luminous flux: 500 lm
Battery: lithium, 3.7 V, 1200 mAh
Charging time: 4–6 h
Sensor range: 0–6 m
Sensor angle: 120°
Material: PC, ABS
Size: 3 × 11 × 14 cm

INSTALLATION

Follow the steps pictured in the chart below to install the Solsense light.

Align the light mount on a wall where you want to install the Solsense light. Use a marker to mark the hole locations.
Using an electric drill, drill three holes into the wall where you marked the locations.
Make sure you use a drill bit with the same diameter as the plastic plugs.
Insert the provided plastic plugs into the holes. Use a hammer to push the plugs completely into the holes. Note that the plugs must fit snugly. If they feel loose, the plugs will be unable to grasp the screws properly.
Use a screwdriver and the three provided screws to screw the light mount onto the wall. Tighten the screws firmly.
There is a threaded hole on the bottom side of your Solsense light. Screw the Solsense light on the light mount and tighten the plastic ring located on the thread of the mount.
Loosen the tightening knob on the light mount to adjust the angle and direction of the Solsense light. Tighten the knob to secure the position. The device is now ready to use.

HOW TO USE

The Solsense light works in three different lighting modes. Use the button on the bottom side of the device to cycle through lighting modes.
Mode 1: When motion is detected, the light shines with its full intensity. Otherwise, the light is dimmed.
Mode 2: When motion is detected, the light shines with its full intensity. Otherwise, the light is off.
Mode 3: The light is always on. After three hours, the light will automatically switch to mode 2.
To turn off the device, press the button again.

WARNINGS

This device uses a solar panel to charge during the day. Make sure that nothing is covering the solar panel. Otherwise, the light will not charge properly.
Make sure that there is no strong light directed onto the solar panel after dark. Otherwise, it will enter the charging mode, and the light will not work.
Do not intentionally shine into the eyes or face.
Do not attempt to open the housing or replace the lamp of the device.
Before each use, check if the light has any visible damage or defect. Do not use it if it is damaged!
Use the product only for its intended purpose.
Do not disassemble or modify in any way.

WARRANTY

The warranty is valid for 24 months. You can claim it from DFVU d.o.o., Liparjeva 6a, 1234 Mengeš, Slovenia, for a replacement product or a refund.

Send us your order number and purchase date in the email, which is available by clicking on our logo in the bottom right corner. The product has a lifetime of 24 months from the date of collection.
WARRANTY

WEEE disposal and recycling symbol

WEEE The WEEE symbol is attached to the product in compliance with the EU directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). It is intended to deter the improper disposal of this product and to promote reuse and recycling.