Netatmo Smart Rain Gauge User Manual
- June 6, 2024
- Netatmo
Table of Contents
Smart Rain Gauge
Sold separately http://netatmo.com/mount
Safety warnings
This device is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge unless they have been given supervision or instruction concerning
the use of the appliance by a person responsible for their safety. Children
should be supervised to ensure that they do not play with the appliance.
Before inserting the batteries, check that the contacts in the device and on
the batteries are clean, and clean them if necessary. Note the polarity (+/-)
when inserting the batteries. Do not throw the batteries into a fire, short-
circuit it or dismantle them. Keep children away from batteries. Seek medical
attention immediately if a battery is swallowed.
EU Declaration of Conformity
Hereby, NETATMO declares that the radio equipment type NRG02 is in compliance
with Directive 2014/53/EU as well as the RoHS Directive 2011/65/EU and its
amendment 2015/863/EU.
Hereby, NETATMO, declares that the radio equipment type NWS03 is in compliance
with Radio Equipment Regulations 2017 and The Restriction of the Use of
Certain Hazardous Substances in Electrical and Electronic Equipment
Regulations 2012. Frequency band: 868.9 – 869.1 MHz / 869.7 – 869.9 MHz / 2400
– 2483,5 MHz.
Maximum transmission power: < 16 mW / 16 mW / 100 mW
The full text of the EU and UKCA declaration of conformity is available at the
following internet address:
http://www.netatmo.com/declaration/nim
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
if this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Should you need further certification information (FCC ID, IC) please remove
the plastic cover of the product.
FCC Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for the
general population (uncontrolled exposure). This device must be installed to
provide a separation distance of at least 20cm from all persons and must not
be collocated or operating in conjunction with any other antenna or
transmitter.
This device NRG02 complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Caution!
This equipment may not be modified, altered, or changed in any way without
signed written permission from NETATMO. Unauthorized modification may void the
equipment authorization from the FCC and will void the NETATMO warranty.
Canadian Compliance Statement
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada.
To reduce potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.
This device complies with Industry Canada RF radiation exposure limits set
forth for the general population (uncontrolled exposure). This device must be
installed to provide a separation distance of at least 20cm from all persons
and must not be collocated or operating in conjunction with any other antenna
or transmitter.
Limited warranty for purchases within Australia
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. The company giving the warranty (the warrantor) is Netatmo Limited., 18/F Wanchai Central Bldg., 89 Lockhart Rd, Wanchai, Hong Kong, contact-support@netatmo.com or contact your local reseller for assistance. The warranty applies for a period of 12 months from purchase from an authorized Netatmo reseller. Any faults or defects arising from misuse or normal wear and tear are not covered by warranty. Any modifications to products will void the warranty. Items not covered by warranty are components that are expected to be replaced regularly, including without limitation: batteries and bracelets. The warrantor has the right to request the return of the product at your expense. The warranty does not cover any consequential loss or damage.
CE marking is the manufacturer’s declaration that the product meets the requirements of the applicable EC directives.
WEEE symbol designates safe and responsible collection, recycling, and recovery procedures for all types of electronic waste. Universal recycling symbol.
The product complies with the Technical Regulations Conformity Certification of Specified Radio Equipment.
The product complies with the requirements of the relevant ACMA Standards.
UKCA marking is the manufacturer’s declaration that the product meets the requirements of the applicable UK directives.
FCC ID: The product complies with the limits for a Class B digital device, pursuant to part 15 of the FCC rules (USA).
IC: The product complies with Industry Canada license-exempt RSS standard(s).
Copyright Netatmo © 2021. All rights reserved. Reproduction and distribution are prohibited without written authorization from Netatmo.
Product Model: NWA01 / FCC ID: N3A-NWA01 / IC: 10860A-NWA01
QSG-RG
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>