Netatmo DTG-US Smart Door and Window Sensors User Manual

June 6, 2024
Netatmo

Netatmo DTG-US Smart Door and Window SensorsSmart
Door and Window Sensors

Smart Door and Window Sensor | User manual
More languages are available at https://sensors.netatmo.com
User guide available in more languages at the following address: https://sensors.netatmo.com
Do not stick your Smart Door and Window Sensors before the setup is complete.
Do not insert the batteries in your Smart Door and Window Sensors until asked in the app.
To start installing your products, open Netatmo Security App.
Go to the Settings menu and choose “Install new products”, then select the Smart Door and Window Sensors and follow the steps in the app.
EU Declaration of Conformity
Hereby, NETATMO, declares that the radio equipment type DTG01 is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address: http://www.netatmo.com/declaration/dtg
Netatmo SAS – 73/77 rue de Sèvres – 92100 Boulogne-Billancourt – France
Wireless connectivity
Bluetooth Low Energy:
2400-2483.5 MHz @ 2.5 mW
Long-range radio: 868.9-869.1 , 869.7-869.9 MHz @16mW

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is  encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body and must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Caution!
Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Limited warranty for purchases within Australia.

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does
not amount to a major failure. The company giving the warranty (the warrantor) is Netatmo Limited., 18/F Wanchai Central Bldg., 89 Lockhart Rd, Wanchai, Hong Kong, contact-support@netatmo.com or contact your local reseller for assistance. The warranty applies for a period of 12 months from purchase from an authorized Netatmo reseller. Any faults or defects arising from misuse or normal wear and tear are not covered by warranty. Any modifications to products will void the warranty. Items not covered by warranty are components that are expected to be replaced regularly, including without limitation: batteries and bracelets. The warrantor has the right to request the return of the
product at your expense. The warranty does not cover any consequential loss or damage.

http://support.netatmo.com

Netatmo DTG-US Smart Door and Window Sensors -
bardcode

Netatmo DTG-US Smart Door and Window Sensors - icon20 FCC ID: N3A-DTG01
IC: 10860A-DTG01
Copyright Netatmo © 2020 All rights reserved.
Reproduction and distribution prohibited without written authorization from Netatmo
V1

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals