NETATMO NIS01-US Smart Indoor Siren User Guide

Smart Indoor Siren
User Guide

User guide available in more languages at the following address:https://indoorsiren.netatmo.com
Before installing the Netatmo Smart Indoor Siren, you need to have the Netatmo Smart Indoor Camera already installed. If that is not the case, install the Camera first and then install the Siren. When installing the Smart Indoor Siren, you will first configure it with the app and then install it to the wall or ceiling. Do not attach your Indoor Siren before setup is complete. Do not pull the plastic from the battery compartment until asked in the app.
You can watch an installation video tutorial online at the following address: https://indoorsiren.netatmo.com

Pack contents

Pack contents:
A. 1 Smart Indoor Siren, 4 AA batteries already inserted
B. 1 mounting plate
C. 2 screws, 2 anchors, and 4 mounting stickers
D. 1 user guide

Required tools (not included)

Required tools (not included):
A. One Phillips screwdriver
B. One-step ladder (only required if you install the Smart Indoor Siren on a high ceiling)
C. One drill – Ø5 mm or Ø0.2 in
D. One pencil
Product setup

|
---|---
Open the Netatmo Security app. Go to the Settings menu and choose “Install new products”, then select the Smart Indoor Siren and follow the steps in the app.| Remove the mounting plate from the Siren and place it next to the camera: 10-20 cm (less than a foot).
|
When asked in the app, pull the plastic from the battery compartment or remove all 4 batteries and reinsert them again (see page 24).| Complete the setup in the app until the Siren appears as an installed accessory of your Smart Indoor Camera. Then proceed to install it on your wall or ceiling

Location advice

The Siren must be installed in the same room as the Camera. There must be no obstacle between them.
It is highly recommended to install the Siren on the ceiling or on top of a wall so that a potential intruder cannot reach it.
1. Installation of the mounting plate

Place the plate so that the Netatmo logo marking is positioned at the top.
Choose whether you prefer to install the mounting plate with the screws (recommended, go to 2A) or with the stickers (go directly to 2B).
2A
Installation of the mounting plate – Screws

Use a pencil to draw two points on a vertical line, separated by 8.5 cm (3.4 in).
Drill one hole on each point and put the screw anchors provided in the holes.
Place the plate in the right position and use the screws provided to secure it to the wall or ceiling.
Skip step 2B.
2B. Installation of the mounting plate – Stickers

Place the four stickers provided at the back of the mounting plate as shown in the picture.
Make sure the surface on the wall or ceiling is flat and clean.
Stick the plate to the wall or ceiling. Push to make sure it stays in place.
3. Installation of the siren

Align the Netatmo logo on the Siren with the marking on the plate.
Push the Siren towards the wall on the plate and turn it clockwise to secure it.
The Siren is now correctly installed.
Changing the batteries

Turn the Siren counterclockwise to take it off the mounting plate.
Unscrew the indicated screw to open the battery lid.
Use 4 AA batteries. Respect the polarity indicated in the battery holder.
Using a USB power adapter (not included)

You can use a micro USB power adapter (5V, 500mA) so the Siren is permanently powered. Leave the batteries inside to use them as power backup.
Once plugged in, put the Siren back on the mounting plate and let the cable run through the notch.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
lf this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Should you need further certification information (FCC ID, IC) please remove the mounting plate and look at the back of the product.
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body and must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation.
Caution!
Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Apple and the Apple logo are trademarks of Apple Inc., registered in the U.S. and other countries. App Store is a service mark of Apple Inc.
Google Play and the Google Play logo are trademarks of Google Inc.
Safety warnings or television reception, which can be determined by turning This device is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
EU Declaration of Conformity
Hereby, Netatmo declares that this NIS01 is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU and ROHS 2011/65/EC. The original EU declaration of conformity may be found at http://www.netatmo.com/declaration/nis.
Netatmo SAS – 93, rue Nationale – 92100 BoulogneBillancourt
Boulogne-Billancourt, 01/12/2018
CEO
Frédéric POTTER

Wireless connectivity
NETATMO ONE (1) YEAR LIMITED WARRANTY.
Netatmo (SAS) warrants the product hardware components (‘Product’) against defects in material and workmanship when used in accordance with Netatmo’s documentation (‘Documentation’) for a period of ONE (1) YEAR after the date of original retail purchase (‘Warranty Period’) from Netatmo or Netatmo’s authorized reseller by the end-user purchaser («Customer» or «you»).

1. APPLICABLE PROVISIONS IN THE EVENT OF A BREACH OF LIMITED WARRANTY
   If the Product fails to conform to the Limited Warranty, Netatmo will, at its sole discretion and upon your submission of a valid claim to Netatmo (i) use commercially reasonable efforts to repair the defective Product with new or refurbished hardware functionally equivalent to the Product being repaired; (ii) replace the defective Product with a Product equivalent to new in performance and reliability, or (iii) exchange the defective Product for a refund of the Product’s purchase price. A returned or repaired Product will be replaced under the terms of the Limited Warranty for the remaining Warranty Period, or ninety (90) days, whichever period is longer. This Limited Warranty is not transferable from the Customer to subsequent Product owners, and the Warranty Period will not be extended for any such transfer.

2. CONDITION OF APPLICATION
   Netatmo’s warranty obligations are conditioned on Customer (i) notifying Netatmo through the contact information available at http://www.netatmo.com during the Warranty Period of any failure of the Product to meet the Limited Warranty, including a detailed description of the alleged failure, (ii) otherwise complying with Netatmo’s then-current return policy (see General Sales Conditions section «Right to cancel and return policy»), (iii) shipping, at Customer’s cost, the affected Product to Netatmo for repair or replacement, and (iv) providing Netatmo with valid proof of purchase. If Netatmo determines, after analysis of a returned Product, that the Product is an eligible Product (see Document and Section of Included Documentation), Netatmo will no longer have warranty obligations. Netatmo will bear all costs of return shipping to Customer, except with respect to any Ineligible Product, for which Customer will bear all shipping costs.

3. EXCLUSIONS
   Netatmo will have no warranty obligation with respect to the following circumstances (‘Exclusions’) (‘Ineligible Products’): (i) a Product that has no defects in materials or workmanship, (ii) Products with defects that are not reproducible by Netatmo, (iii) Products marked as ‘sample’ or sold ‘AS IS’, (iv) Products whose serial number has been defaced or removed, or (v) Products that have been subject to (a) any modifications, alterations, repair, or service by any party other than Netatmo or Netatmo’s uthorized representatives; (b) handling, storage, installation, testing, or use not in accordance with the applicable Documentation; (c) abuse, negligence, neglect, accidents, abuse or misuse; (d) any breakdowns, fluctuations, or interruptions in electric power or the telecommunications network; or (e) any Acts of God, including fire, flood, tornado, earthquake, hurricane, excessive snow, lightning, riot, insurrection, the act of war or another disaster.

4. WARRANTY DISCLAIMER
   EXCEPT TO THE EXTENT SET FORTH ABOVE IN THIS LIMITED WARRANTY, THE PRODUCTS ARE PROVIDED ON AN ‘AS IS’ BASIS, AND NETATMO DISCLAIMS ALL WARRANTIES AND CONDITIONS WITH RESPECT TO THE PRODUCTS, WHETHER IMPLIED, EXPRESS, OR STATUTORY, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, TITLE, NON-INFRINGEMENT OF THIRD PARTY RIGHTS, QUIET ENJOYMENT, AND ACCURACY. NETATMO DOES NOT WARRANT THAT OPERATION OF THE PRODUCTS WILL BE ERROR-FREE OR UNINTERRUPTED OR THAT THE PRODUCTS WILL IN EVERY CASE PROCESS ALL DATA CORRECTLY.

5. LIMITATION OF LIABILITY
   5.1 IN NO EVENT WILL (a) NETATMO BE LIABLE FOR ANY CONSEQUENTIAL, EXEMPLARY, SPECIAL, OR INCIDENTAL DAMAGES, INCLUDING ANY DAMAGES FOR LOST DATA OR LOST PROFITS, ARISING FROM OR RELATING TO THIS LIMITED WARRANTY OR THE PRODUCTS, EVEN IF NETATMO KNEW OR SHOULD HAVE KNOWN OF THE POSSIBILITY OF SUCH DAMAGES, AND (b) NETATMO’S TOTAL CUMULATIVE LIABILITY ARISING FROM OR RELATED TO THIS LIMITED WARRANTY AND THE PRODUCTS, WHETHER IN CONTRACT OR TORT OR OTHERWISE, EXCEED THE FEES ACTUALLY PAID BY CUSTOMER TO NETATMO OR NETATMO’S AUTHORIZED RESELLER FOR THE PRODUCT AT ISSUE IN THE PRIOR 12 MONTHS (IF ANY). THIS LIMITATION IS CUMULATIVE AND WILL NOT BE INCREASED BY THE EXISTENCE OF MORE THAN ONE INCIDENT OR CLAIM. NETATMO DISCLAIMS ALL LIABILITY OF ANY KIND OF NETATMO’S SUPPLIERS;
   5.2 THE NETATMO ONLINE SERVICES (‘SERVICES’) ROVIDE YOU INFORMATION (‘PRODUCT INFORMATION’) REGARDING INDOOR AND OUTDOOR MEASUREMENTS. WITHOUT LIMITING THE GENERALITY OF THE DISCLAIMERS ABOVE, ALL PRODUCT INFORMATION IS PROVIDED FOR YOUR CONVENIENCE, ‘AS IS, AND ‘AS AVAILABLE. NETATMO DOES NOT REPRESENT OR WARRANT THAT PRODUCT INFORMATION WILL BE AVAILABLE, ACCURATE, OR RELIABLE. YOU USE ALL PRODUCT INFORMATION, THE SERVICES, AND THE PRODUCT AT YOUR OWN DISCRETION AND AT RISK. YOU WILL BE SOLELY RESPONSIBLE FOR (AND NETATMO DISCLAIMS) ANY AND ALL LOSS, LIABILITY, OR DAMAGES RESULTING FROM YOUR USE OF THE PRODUCT INFORMATION, SERVICES, OR PRODUCT.

6. CONSUMER PROTECTION
   SOME STATES DO NOT ALLOW THE EXCLUSION OF IMPLIED WARRANTIES OR THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE. THE DISCLAIMERS, EXCLUSIONS, AND LIMITATIONS OF LIABILITY UNDER THIS LIMITED WARRANTY WILL NOT APPLY TO THE EXTENT PROHIBITED BY APPLICABLE LAW.

https://support.netatmo.com
Product model: NIS01
FCC ID: N3A-NIS01
IC: 10860A-NIS01
Copyright Netatmo © 2018 All rights reserved. Reproduction and
distribution prohibited without written authorization from Netatmo
NIS-V1
More languages are available athttps://indoorsiren.netatmo.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>