motionics VibeSense Vibration Analyzer User Guide
- June 8, 2024
- motionics
Table of Contents
VibeSense Vibration Analyzer
User Guide
Important Notes
- Turn o! the device after use. It will NOT turn o! automatically.
- Do NOT open the device. Opening causes permanent damage and voids the warranty.
- This device is pre-calibrated. You will need a 1g 159Hz vibration shaker if you want to calibrate it again.
Description
-
Mounting Hole – connect to magnetic base or #xture with ¼-28 set screw
-
Magnetic Switch Sensing Region – move magnetic switch key close to turn the device on/o!
-
Status LED
– Device is on (“ashing)/device is connected (solid)
– Device is in charge
– Device is fully charged -
Tachometer Connector – connect to laser tachometer sensor (available in rotor balancing kit)
-
Wireless Charging Coil – “ip the device and place on wireless charging pad to recharge battery
Included in the box
- VibeSense Wireless Accelerometer
- Magnetic On/O! Switch Key
- ¼-28 Accelerometer Mounting Set Screw
- Qi Wireless Charging Pad
- USB Charging Cable
- USB Power Adapter
- User Guide
Compatible Software
- iOS: VibraTestPro
- iOS app can be directly downloaded from the App Store
Quick Start
- Attach VibeSense wireless accelerometer to the testing machine/#xture directly with 1⁄4-28 set screw or via magnetic base.
- Move magnetic switch key close to the sensing region on VibeSense accelerometer to turn on the device.
- Launch VibraTestPro app.
- Go to the Setting page in the app and make sure Wireless is selected for Sensor.
- On the main page, tap the Sensor button on the bottom right corner to bring up the sensor pairing/status page.
- Move the iPad close to the accelerometer; it will be detected and connected.
- Tap the Vibration Meter button to launch ISO-10816 based vibration meter and tap Update to get overall RMS reading.
- Tap the Spectrum button to launch the signal viewer for vibration waveform and
- FFT spectrum. Tap the Update button in the middle of bottom tool bar to receive raw signal.
- Tap Record button to launch signal recording page to record raw vibration signal.
- To disconnect the device, go to the sensor pairing/status page again and tap the Disconnect button.
- To turn o! the device, move the magnetic switch key close to the sensing region on the VibeSense accelerometer.
- To recharge the device, “ip and place it on the wireless charging pad.
Motionics, LLC www.motionics.com
info@motionics.com
8500 Shoal Creek Blvd Building 4 Suite 209, Austin, TX, 78757
© 2020 Motionics, LLC.
All rights reserved. Made in the U.S.A
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>