AURA Running Board Lighting Kit Installation Guide
- June 8, 2024
- Aura
Table of Contents
RUNNING BOARD
INSTALLATION GUIDE
MAIN COMPONENTS
INSTALLATION
STEP 1
Decide where to locate the control box and ensure wiring has enough length for
light bars to be installed in desired location.
IMPORTANT:
The control box must be installed inside the vehicle as it is not waterproof.
Avoid installation areas of the engine bay + heated surfaces.
IMPORTANT:
The extension wires are on the led bar. Lay out the bars to measure the length
prior to install for a successful installation.
2 x 48” LED Bar + 8ft extension wire
1 x 36” LED Bar + 18ft extension wire
1 x 36” LED Bar + 8ft extension wire
Once connected, plug the control box Cigarette Power Adapter into an available 12 volt charging port.
or connect the positive wire to the fuse tap and connector the open negative
wire to a ground (any metal surface). Then plug the fuse tap into the 10amp
switched fuse.
IMPORTANT: Connecting to more then 10amp will override the kit and cause
early failure, ensure it is 10amps or less!
WARNING: Please ensure that the led bars or strips/control box/wiring all are mounted in areas where will not exceed 85C or 185F.
STEP 2
Secure Control box in desired location with Velcro or zipties.
- CONTROL BOX NOT WATERPROOF
Ensure the control box is safely and securely hidden from exposing elements of moisture.
STEP 3
Mount brackets to secure the light bars first. Secure the light bars using the
zip ties to tie all the wiring away from the moving components.
* IMPORTANT:
The LED connectors are not waterproof.
You will need to use HEAT SHRINK TUBE (not included) or ELECTRICAL TAPE around
the LED connectors to ensure the longevity of the lighting kit.
STEP 4 Using the included E-Z Remote, select your desired color or
pattern.
www.OPT-7.com
AUX WIRING FOR A DOOR/DOME LIGHT
Please scan to see a detail instruction on Door Assist Sync or go to
https://wintis.ladesk.com/549690-AURA-Door-AssistAUX-Installation-Guide
http://qr.w69b.com/g/pa9DknB6g
OPTIONAL UPGRADE
Upgrade your Aura Original Control Box to the Aura Pro Bluetooth Control
Box.All new AURA Pro Bluetooth is App enabled by a smartphone controller (iOS
& Android
Compatible).
DISCLAIMER
OPT7 Lighting is not liable for damages or personal injuries while installing this product. The Installation Guide is intended as assistance to reduce setup time. OPT7 Lighting assumes no responsibility for improper installation. If you are unfamiliar with your vehicle or inexperienced with aftermarket upgrades, please seek professional assistance.
OPT7 recommends installation for safety and guidance.
Modified installations or installation recommendations not specified by OPT7
Lighting will void product warranty.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>