SCHLAGE ND Series Electrified Cylindrical Lock User Guide
- June 8, 2024
- Schlage
Table of Contents
SCHLAGE ND Series Electrified Cylindrical Lock
IMPORTANT: DO NOT insert key in outside cylinder (if applicable) before
or during these steps!
NOTICE
FAILURE TO PROPERLY TIME THE LOCK WILL RESULT IN IMPROPER FUNCTION, AND CAN
CAUSE DAMAGE TO THE LOCK.
Tools Needed
-
Step 1
-
Install Lock
EXCEPT INSIDE LEVER
ND60 (including XN12-001), ND66, ND75, ND78 ND93, ND95, ND98 -
Install Lock
EXCEPT OUTSIDE LEVER
ND70, ND25x70, ND70x80, ND73, ND81, ND94, ND97 -
Install Lock
EXCEPT BOTH LEVERS
ND72 (including XN12-002 and XN12-003)
-
-
Step 2
- From INSIDE, rotate key cam CCW until it stops.
-
Step 3
- Step 4
Install Cylinder and Lever
With key rotated 90° clockwise, press lever onto lever post.
For IC Cylinders:
Align cylinder tailpiece blade and keyway.
Turn the key 15° and hold.
Then, insert assembly into lever.
- Step 5
Check Operation
See chart below for correct key rotation.ND66 **ND72* ND75 ND95| INSIDE** rotates 360° to lock and unlock.
OUTSIDE rotates 360° to lock and unlock.
---|---
ND78 ND98| INSIDE and OUTSIDE
rotate 180° and back.
CW to unlock.
CCW to lock.
ND60 ND93| INSIDE rotates 360° to lock and unlock.
OUTSIDE rotates to retract latch.
ND70 ND25X70 ND70X80 ND94| OUTSIDE rotates 360° to lock and unlock.
ND81| OUTSIDE rotates 90°
CCW to retract latch
OUTSIDE rotates 180° CW to allow lever to retract latch.
ND73 ND97| OUTSIDE rotates 360° to lock and unlock.
When OUTSIDE is locked by push button, OUTSIDE key should rotate 45° to unlock.
ND72* : Follow steps 2-5 to time inside lever, then continue to step 6.
- Step 6
Troubleshooting
If your lock does not allow you to remove key, remove keyed lever, rotate key 180° and reinstall.
Remove Keyed Lever
To remove a keyed lever, rotate key 90°.
Insert pin wrench and push against lever catch. Pull off the lever.
© Allegion 2021 Printed in U.S.A. P517-432 Rev. 01/21-d
ND-Series Timing Guide
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>