EGO AVB2120 Snow blower Rubber Belt User Manual
- June 8, 2024
- EGO
Table of Contents
EGO AVB2120 Snow blower Rubber Belt
The belt is designed to only be used with EGO POWER+ 56-VOLT LITHIUM-ION CORDLESS SNOW BLOWER SNT2120AP.
WARNING: Make sure to turn off the unit and remove the battery pack(s) before performing any maintenance task on your snow blower
Required tools (not included):
- T20 Torx screwdriver
- Needle nose pliers
HOW TO OPERATE
-
Remove the drive belt cover by removing the 9 Torx screws as shown in Fig. 1 & 2
-
Remove the spring from the hook to release the belt tension (Fig. 3 & 4).
-
Remove the drive belt by slowly turning the auger pulley counterclockwise while pulling the belt outwards (Fig. 5).
-
Install the new drive belt by rotating it onto the pulleys (Fig. 6).
Tips: Rotate the new drive belt first around the motor pulley, then the idler pulley, and finally, around the auger pulley. Slowly turn the auger pulley clockwise to drive the belt inwards. -
Use needle nose pliers (not included) to install the spring onto the hook to tension the drive belt (Fig. 3).
-
Reinstall the drive belt cover and secure it with the 9 Torx screws removed in step 1 (Fig. 1).
1-855-EGO-5656 (1-855 -346-5656)
EGOPOWERPLUS.COM
EGO Customer Service
769 Seward Ave NW #102
Grand Rapids, MI 49504
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>