WEEFINE Solar Flare 13000 Under Water Video Light User Manual

June 8, 2024
WEEFINE

WEEFINE Solar Flare 13000 Under Water Video Light User Manual

13000 Lumens Flood.
Waterproof to 100m/330ft

Standard Accessories

Specification

Features

Battery Installation and Removal

  1. Open the rear cover of the battery canister, and put the lithium battery pack into the battery canister (as shown in the figure); pay attention to the front of the battery contact ring, and then tighten the battery canister;
  2. To take out the battery (if the flashlight has been vacuumed before), you need to release the pressure first; unscrew the air vent sealing cover, pull the yellow sealant plug, and after hearing the sound of air intake, unscrew the battery canister smoothly and take out the battery.

Operating the light

Turn ON:
In the off state, press the left and right buttons at the same time for 0.5 seconds to turn on the power, short press the left button to enter the working mode, the brightness is 100%.

Turn OFF:
In any mode, under any brightness, press and hold the left and right buttons at the same time for more than 2 seconds until it is turned off.

Adjusting the brightness:
To increase the brightness:Press and immediately release the right button.
To decrease the brightness:Press and immediately release the left button.

Strobe mode

Select the focus light level (generally choose low light) and press the right button for 1.5 seconds to enter (exit) the strobe mode; you can set the brightness of the strobe, as shown in the figure below.

(Strobe Port)

Connect the camera’s flash port to the flashlight’s strobe port with an optical fiber cable. When the camera’s flash signal transmitted by the optical fiber is detected, the flashlight instantly switches to the set flashing brightness.

Use weefine fiber optic cable for matching (optical fiber cable is optional)

Emergency Mode
On/Off: In the case of power on, long press the left and right buttons for more than 2 seconds to enter (exit) SOS mode; short press the right button to switch between SOS mode and flash mode.

Remote control

Use weefine dedicated remote control (optional)

Focus Light Out Function
In the strobe mode, adjust the brightness to 0% to realize the function of focusing and turning off the lights.
When the light sensor of the lamp head detects the flash signal, the flashlight will turn off the focus light, and the flashlight will turn on again after 1 second.

Sleep Mode:
In the power-on state, long press the left button for more than 2 seconds to enter (exit) sleep mode, and only the indicator light will be on.

Vacuum Operation

Air Extraction Indicator

  1. Flashes quickly when pumping (5Hz per second);
  2. The vacuuming is completed; the yellow indicator light is always on;
  3. The yellow indicator light flashes slowly, which means air leakage or poor sealing;

After the pumping is completed, it is necessary to cover and tighten the sealing cap

  • If the yellow indicator is flashing, the sealing ring is bad, please check whether the sealing position is normal;
  • In normal use, if the yellow indicator light is flashing, the seal is not good; it may be that the lamp has entered the water, which needs to be dealt with in time.

Warnings

  1. Do not open the tail cap when the video light is in the water.
  2. Do not direct light to human eyes.
  3. Do not touch the battery and charger with wet hands.
  4. Use only the manufacturer’s battery and charger with this system.
  5. If the video light will not be used for a long period of time, the battery should be removed.

Failure to comply with these warnings may result in damage to the video light and will nullify the warranty.

Warranty

Weefine provides a warranty against manufacturer defects for 1 year starting from the date of purchase. Manufacturer defects occuring within 15 days of the date of purchase will result in an exchange of product at the vendor. All other manufacturer defects occuring within 1 year of the purchase will be repaired at no cost. Proof of purchase is required for warranty support. The warranty does not cover failures or defects resulting from misuse (e.g.; modification; damage), natural disasters, or battery issues, including incorrect battery installation.

Trouble Shooting

Before returing the video light to the vendor, please try the following:

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals