WEEFINE WED-7 Pro HD Portable LCD Monitor User Manual
- June 10, 2024
- WEEFINE
Table of Contents
WED-7 Pro 4K HDMI input/output signal
HD Portable LCD Monitor
User Manual
Precaution
- Do not expose the LCD screen to direct sunlight as it will damage the screen. Be careful when placing the monitor in a high place or a place without fixture.
- If the monitor is used in a cold place, horizontal lines or a residual image may appear on the screen. This s not a malfunction. When the monitor becomes warm,the screen returns to normal.
- If you have been displaying the same image for a long time, such as a split image, time code or still image, the image may remain on the screen and be superimposed as a ghost image.
- The LCD panel of this monitor is manufactured with high precision technology. Thus a very small proportion of pixels may be stuck, either always off(black), always on(red, green, blue) or flashing state. In addition, over a long period of use, because of the physical characteristics of the liquid crystal, such stuck pixels may appear spontaneously. These problems are not malfunctions.
- Use branded batteries and charging devices to reduce battery risks caused by poor charging,
Safety and Product Information
- Please do not disassemble the waterproof shell of the monitor by yourself to avoid damage caused by personal disassembly and repair
- Do not place the monitor waterproof case in direct sunlight or high temperature for a long time.
- Use a soft cloth (such as a cleaning cloth or a glass cleaning cloth) to gently wipe the display.
- If the monitor case is not used for a long time, please take out the battery in time and store it in a dry and cool place.
- When it is used underwater, do not unscrew, unplug the HDMI cable at both ends of the hardware plug and the lithium battery cover to prevent leakage and damage to the electronic components inside the monitor and LCD screen.
- After use, be sure to put the monitor waterproof case in fresh water, shake, clean and soak for 30 minutes to remove the salt and impurities attached to the shell and avoid the case being corroded and rusted. f the parts get rusted, because they are not cleaned after use and lead to water leakage, maintenance costs must be borne by the user.
Attention
Please read this manual carefully.
No matter it is in use or in storage, do not place it in any of the following
locations, otherwise it may lead to a malfunction.
- Location with excessive vibration
- Location with strong electromagnetism
- Location that is exposed to direct sunlight
- Location that is exposed to very hot place. (0-50 degrees Celsius)
Checking the accessories
check the following accessories are supplied:
- Monitor + Universal Adapter
- User Manual
- Warranty Card
- Battery Charger
- 18650 Battery x2
- HDMI cable x1
Product Description
The WED-7 Pro is a professional HD monitor specially designed for
underwater photographer. The product is made of aluminum alloy, with carbon-
fiber trim panels and delicate stainless-steel chrome-plated buttons. It is
High-end and professional product.
The WED-7 Pro is a professional HD monitor specially designed for
underwater photographer. The product is made of aluminum alloy, with carbon-
fiber trim panels and delicate stainless-steel chrome-plated buttons. It is
High-end and professional product.
- Professional auxiliary shooting function:The product has a variety of professional shooting functions, such as: brightness histogram, audio column, auxiliary focus, false color, exposure prompt, monochrome display, nine grid, square, etc., all can better help the photographer in the process of shooting and creating works, effectively monitor and control the picture.
- Long back-up life:The product is powered by two 18650 lithium batteries, the longest working time can be up to 3.5 hours, and the product has a battery indicator light, so that the photographer can observe the battery power at any time.
- 4K signal transmission: The product supports 4K HDMI input and output, and high-definition pictures of the camera can be displayed on the monitor in real time through 4K signal transmission of HDMI.
- 7-inch FHD: The product features a 7-inch full HD screen with 1920×1200 resolution and 440PPI pixel density, as well as SOOCD /m² high brightness and 1200:1 high contrast.
- Ultra-wide viewing Angle:The IPS display of choice has an ultra-wide viewing Angle of 160°, which allows the photographer to easily get a clear picture when adjusting the position.
- True color: The product uses the trustworthy Rec.709 high-definition color standard in the professional field, and accurately restore the color without distortion or color bias, it shows the real image.
- Hood: The product design has a professional hood, so that the photographer can get the ideal viewing effect when using in the outdoor bright light.
- Excellent image processing engine: the product is matched with an independent image processing engine, which improves the light and dark effect and contrast of the picture, so that the picture quality is more exquisite.
- Excellent deep waterproofing effect: UP to 80m/263ft IP68 waterproofing grade: professional waterproofing design, full process technology and quality control, as well as real simulation of various deep water conditions of pressure testing.
Parts identification
- Left key
- Menu/OK Key
- Right key
- F1 Shortcut key
- F2 Shortcut Key
- F3 Shortcut Key
- F4 Shortcut key and Return key
Parts Operation
Up/down button, left/right button, +/- button
According to different page operations can be up and down keys, left and right
keys, plus or minus keys;
[MENU/OK] MENU/confirm button
It can be a menu button or a confirm button;
[F1/F2/F3 1 Shortcut keys
F1 pseudo color; F2 focus; F3 center mark; F4 security box;
[ /Fa 1 Quick and return keys
F4 security box; O as a return function button;
Power on/off button; Power indicator
Long press the power button for one second to start up; Long press the power
off button for two seconds to shut down; When the monitor s on, the power
indicator is green, indicating that the monitor is fully charged. If the power
indicator s red, the current power is not fully charged
(Note: the specific power indicator s subject to the power grid display on the
display screen; Long press the power button to start up, when the power
indicator is on, the display screen will display the content within 1~ 5
seconds.This s the normal startup state of the display screen, not a fault)
4K HDMI input and output
3840X2160P (30/29.97/35/24/23.98Hz)
4096X2160P ( 24Hz)
Install Battery and Uninstall The Adapter
As shown in the figure, install two 18650 batteries in the positive and negative direction into the battery compartment.
HDMI Cable Connection
Warning
If the input/output interface s not connected, keep the protection cover
sealed. Otherwise, the product will be damaged by water.
When the HDMI signal cable is connected to the camera, if there is o video
display,please check whether the camera has HOMI output signals, or whether
the HDMI signal cable is connected successfully
Menu Operation
Menu Operation-1
Before setting, make sure the monitor is connected with correct signal input.
Press and hold on the power button to turn on the device, then press the menu
button and the function menu dialog will appear, press < > to select the
required options.
Picture Mode | Standard/User! Dynamic/Soft |
---|---|
Contrast | 0∼100 ( 50 by default ) |
Brightness | 0-100 ( 50 by default ) |
Saturation | 0-100 ( 50 by default ) |
Sharpness | 0-100 ( 50 by default ) |
Backlight | 0100 ( 80 by default ) |
Color Temp | User/6500K/7200K/9300K |
Red | 0-255 ( 128 by default ) |
Green | 0-255 ( 128 by default ) |
Blue | 0255 ( 128 by default ) |
Menu Operation-2
Peaking | 1 /2/3/4/5/6/7/8/9/10/off |
---|---|
Peaking Color | Red / Green / Blue |
False Color | OFF / ON |
Exposure | OFF / 70IRE / 1001RE |
Monochrome | OFF / Gray / Red / Green / Blue |
Aspect Ratio | Auto/4:3/14:9/16:10/16:9/1.85:1/2.35:1/Full |
Pix to Pix | OFF/ON |
Scan Mode | Under scan/Over scan |
Freeze | OFF / ON |
Zoom | OFF/ 1.4X/ 2X/4X/ 8X / 19, . |
Camera Mode | OFF/ ON |
Menu Operation-3
Screen Mark | OFF / 80% / 85% / 90% / 93% / 96% |
---|---|
Center Mark | OFF / ON |
Make Ratio | OFF / 4:3 / 2.35:1 / 1.85:1 |
Make Color | White/Black/Red/Green/Blue |
Mark Thick | 1/2/3 |
Border Trans | OFF / 1 / 2 / 3 |
Menu Operation-4
Volume Bar | OFF / ON |
---|---|
Histogram | OFF / ON |
Vector | OFF / ON |
Parade | ON / RGB / YCBCR /YUV |
3DLUT | OFF / ON |
LUTTABLE | USER/RED-LOG-1 /DJI-LOG-1 /5-LOG-1N-LOG-1 |
Menu Operation-5
Signal Source | HDMI /Video |
---|---|
Language Choice | Chinese / English |
Reset | OFF / ON |
Transparency | Close / Low / Middle / High |
Osd Timeout | Close 5 seconds / 10 seconds / 15 seconds |
Battery Status | ON / OFF |
Menu Operation-6
Fl| false color/peaking / peaking color / center mark /screen mark / image
scale / scan mode / pix to pix / zoom / Filp-H / Filp-V/ Freeze / camera mode
/ mute state / Exposure / Histogram /Volume Bar / RGB histogram / Parade
Waveform / vector graph / battery status / Monochrome display
---|---
F2| false color / peaking / peaking color / center mark / screen mark / image
scale / scan mode / pix to pix / zoom / Filp-H / Filp-V/ Freeze / camera mode
/ mute state / Exposure / Histogram / Volume Bar / RGB histogram / Parade
Waveform / vector graph / battery status / Monochrome display
F3| false color / peaking / peaking color / center mark / screen mark / image
scale / scan mode / pix to pix / zoom / Filp-H / Filp-V / Freeze/ camera mode
/ mute state / Exposure / Histogram /Volume Bar / RGB histogram / Parade
Waveform / vector graph / battery status / Monochrome display
F4| false color / peaking / peaking color / center mark / screen mark / image
scale / scan mode / pix to pix / zoom / Filp-H / Filp-V / Freeze / camera mode
/ mute state / Exposure / Histogram / Volume Bar / RGB histogram / Parade
Waveform / vector graph / battery status / Monochrome display
Troubleshooting
Please check the monitor according to the following steps before you ask for repair service.
Malfunction | Causes and Measures |
---|---|
Cannot connect this monitor to the camera | – incorrect type of adapter socket |
used
– Check the camera hot shoe type and select the correct hot shoe adapter
No image appears on the screen of the monitor| – Me camera is in power saving
mode
– Carry out some camera function such as half-pressing the shutter button to
exit power saving mode
– The HDMI cable is disconnected→Reconnect it properly
– The shooting image may not be displayed on this unit when using a camera
that does not have the live view function. Refer to the instruction manual of
the camera for details
– The HDMI signal channel is incorrectly selected, please select it again in
the menu: AV/HDMI
Product screen shows no signal| – Whether the camera has HDMI signal output
function; Whether the HDMI high-definition signal cable is successfully
connected
Cannot shoot| – Depending on the camera, when the camera connects to this
monitor switch the camera to shooting mode before taking pictures
Black stripes appear on the screen| – The aspect ratio of the LCD panel of
this monitor is 16:10. so black stripes may appear depending on the image
Available signal formats
The monitor is applicable to the following signal formats:
System| Total lines| Active lines| Frame rate|
Scanning| Aspect ratio
---|---|---|---|---|---
575/50l(PAL)| 625| 575| 25| 2:1 interlace| 16:9 / 4:3
480/6010 TSC)| 525| 483| 30| 2:1 interlace| 16:9 / 4:3
5756/5OP| 625| 576| 50| Progressive| 16:9 / 4:3
480/60P| 525| 483| 60| Progressive| 16:9 / 4:3
640×480/60P| 525| 480| 60| Progressive| 4:03
1080/501| 1125| 1080| 25| 2:1 interlace| 16:09
1080/601| 1125| 1080| 30| 2:1 interlace| 16:09
720/50P| 750| 720| 50| Progressive| 16:09
720/60P| 750| 720| 60| Progressive| 16:09
1080/50P| 1125| 1080| SO| Progressive| 16:09
1080/60P| 1125| 1080| 60| Progressive| 16:09
3840×2160/30P| 2250| 2160| 30| Progressive| 16:09
3840×2160/25P| 2250| 2160| 25| Progressive| 16:09
3840×2160/24P| 2250| 2160| 24| Progressive| 16:09
1096×2160/24P| 2250| 2160| 24| Progressive| 16:09
Product specifications and external appearance are subject to change without notice.
Parameter
Model | WED-7PRO |
---|---|
LCD display | Screen |
Resolution | 192011200 pixel |
Brightness | 500cd/m2 |
Viewing angle | 160° |
Input signal interface | HDMI IN |
Output signal interface | HDMI OUT |
Power supply | 18650 batteryX2 (3400 mAh) |
Working temperature | Operating temperature |
Storage temperature | -20 to +60°C (-4 to +140°F) |
Working hours | ≈ 3.5 hrs |
Waterproof rating | 80m / 236ft |
Dimension | 198 x 132 x 39 mm |
Weight | 1230g (Land) ; 280g (Underwater) |
T-inch HD waterproof monitor waterproof depth 80m
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>