Signature Hardware 939203 Leaman 4.5-in 1-Light Bronze Modern/Contemporary Vanity Light Instruction Manual
- June 8, 2024
- Signature Hardware
Table of Contents
Signature Hardware 939203 Leaman 4.5-in 1-Light Bronze
Modern/Contemporary Vanity Light
VANITY LIGHT
BEFORE YOU BEGIN
We recommend consulting a professional if you are unfamiliar with installing
lighting fixtures. Signature Hardware accepts no liability for any damage to
the faucet, plumbing, sink, counter top, or for personal injury during
installation. Observe all local plumbing and building codes. Unpack and
inspect the product for shipping damage. If any damage is found, contact our
Customer
Relations team via live chat at
www.signaturehardware.com or by emailing
support@signaturehardware.com.
GETTING STARTED
Ensure that you have gathered all the required materials that are needed for the installation.
FOR YOUR SAFETY
WARNING: Be sure the electricity to the wires you are working on is shut off, either the fuse is removed or the circuit breaker is shut off. You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Under no circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be installed on a ceiling which contains a radiant type heating system. Read instructions carefully. If you are unclear as to how to proceed, consult a qualified electrician.
CARE INSTRUCTIONS
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap. Do not use abrasive materials such as scouring pads or powders, steel wool or abrasive paper.
TOOLS AND MATERIALS
SAVE THIS MANUAL: RETAIN FOR CONSUMER’S USE. READ THESE INSTRUCTIONS COMPLETELY BEFORE INSTALLING THE PRODUCT: FOR PRODUCT OR INSTALLATION QUESTIONS PLEASE CALL CUSTOMER SERVICE AT 1-800-221-3379
INSTALLATION
-
Secure circular strap (A) to the outlet box with outlet box screws (B).
-
Connect the white wire from the fixture to the white wire from the outlet box and the black wire from the fixture to the black wire from the outlet box. Cover the two wire connections using the two provided wire connectors. Wrap the two wire connections with electrical tape for a more secure connection. Attach the grounding wire connections with electrical tape for a more secure connection. Connect the copper ground wires from the fixture and from the outlet box to the ground screw on the circular strap.
Note: If you have electrical questions, consult your local electrical code for approved grounding methods. -
After wires are connected, tuck them carefully inside outlet box. Raise the front plate (F) to the circular strap (A) and the raised dimple (C) to the hole (D), then secure with the screw (E).
(FIG 2)
- Slip the glass (K) over the socket (I) and the clip (H) into the glass holder (G).
- Install light bulb (J) (Provided). Please do not exceed the maximum wattage capacity recommended on the socket (I).
1.855.715.1800
signaturehardware.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>