Chacon 34046 Wireless Remote Keyboard User Manual

Chacon 34046 Wireless Remote Keyboard

WHAT IN BOX

Registering the guarantee

To register your warranty, fill in the online form at www.chacon.com/warranty

Product overview

1. LED indicator
2. Keypad

Introduction

Thank you for using this product.

• Please read all instructions carefully before using the product.
• Don’t attempt to disassemble or repair the product yourself, as this will invalidate the warranty.
• In order to use this product, you must have a simple or code unit. (Compatible reference: 34035, 34036, 34038, 34043, 34044, 34045, 34048)

Battery installation: remote keyboard

1. Using a flat screwdriver to separate the two parts of the keyboard.
2. Insert the battery taking care to respect the polarity (+/-)
3. Close the compartment

Link the remote keyboard with a central unit

1. Using a screwdriver, open the battery compartment of the main unit.
2. Press and hold the learn button until you hear a «beep». The unit enters pairing mode.
3. Press any button on the remote keypad. You will hear a «beep» sound to indicate successful pairing.
4. To exit pairing mode, press and hold the learn button for 3 seconds. You will hear a double «beep».

NOTE : A maximum of 32 transmitters can be paired to a main unit

Setting up the personal code

Once you have placed your batteries, you have 15 seconds to choose a four- digit code. If you have not had time to enter your personal code, the code 1234 will be saved by default

Note : Each time you install batteries, you will need to set up your 4-digit code again

Functionality of the keypad

• HOME Mode: Enter your 4-digit code, then press the «1» button. You will hear a «beep» to indicate that the alarm will enter «home» mode after 30 seconds
  NOTE : In this case, the motion detection function is disabled. Only the opening detector will trigger an alarm. This mode is also available on the remote control.

• AWAY mode: Enter your 4-digit code, then press the «2» button. You will hear a «beep» to indicate that the alarm will enter the «Away» mode after 30 seconds.
  NOTE : In this case, if someone opens the door or window equipped with the opening detector or enters the field of vision of your motion detector, the alarm will be triggered. This mode is also available on the remote control.

• Emergency mode: Press buttons 1 and 4 simultaneously in case of emergency. An alarm will sound without time limit to scare off intruders

Reset pairing

In order to reset your entire alarm, remove the batteries from your device. Then press and hold the learning button (See central alarm manual). When you reinsert the batteries, you will hear two «beeps» indicating that the reset was successful.

Problem solving

1. 1. False alarms from the main unit
2. Check that there are no animals near the motion detector.
3. In hot weather, moving shadows may also activate the alarm. Also ensure that the detector is not installed near a radiator or heat source.
4. Check that there are no devices with strong electromagnetic fields near the door/window sensor. Strong electromagnetic fields can cause false alarms.
5. The main unit doesn’t receive a signal from the transmitter
6. Check if the pairing between the transmitter and the main unit was successful.
7. If pairing was successful, check the battery voltage of the main unit and transmitter. Low voltage will result in product failure.
8. No alarm sounds after a detection
9. Check if the low battery indicator is flashing (please replace the batteries immediately).
10. If the unit is armed and set to HOME mode and the PIR sensor detects an intrusion, the alarm will not sound. The PIR sensor is disabled in HOME mode. Check if the main unit is installed correctly

Add a device to your existing alarm

• We have created a 100% compatible alarm system to meet your needs. Here, we offer accessories that can work alone but also as a kit. This allows you to personalise your alarm and to associate several accessories but also several alarms between them.
• For example, when a person triggers the opening detector, all your alarms will sound. You can deactivate your alarm using the code units, remote control or the remote keyboard

More information on our website: https://chacon.com/fr/

Compatible products : 34035, 34036, 34038, 34043, 34044, 34045, 34048

Safety advice

• Don’t mix new and used batteries.
• Don’t mix alkaline, standard (zinc carbon) or rechargeable (ni-cad, ni-mh, etc.) batteries.
• Please use only the type of battery specified in the manual.
• Don’t leave used batteries lying around in the unit, as this may damage the unit.
• Incorrect use of the battery may damage nearby objects and result in fire or serious injury.
• Please keep batteries away from children. If you suspect that batteries have been ingested, seek medical attention immediately. Swallowing the battery can lead to serious consequences; internal burns within 2 hours or death.
• Recycle used batteries in accordance with environmental protection practices
• Don’t place the unit near a heat source, where it may be exposed to direct sunlight, rain or strong light.
• The unit is not waterproof. Don’t expose it to rain or immerse it in water.
• Don’t attempt to disassemble or repair the product yourself.
• Please keep this manual in a safe place.
• The reception distance may be affected if a strong interference signal exists in the area of use.

Technical specifications

• Easy to install
• Compatible products: 34035, 34036, 34038, 34043, 34044, 34046, 34048
• Battery: 2xAAA 1,5V (not included)
• Standby current: ≤ 3uA
• Alarm current : ≤ 15mA
• Box content: remote keyboard + manual + fixing kit

For indoor use only

DISPOSAL

This product must be treated in accordance with European Directive 2002/96/EC with the aim of being recycled or dismantled to minimise its impact on the environment. For further information, please contact your local or regional authorities

EU declaration of conformity

Hereby, Chacon declares that the radio equipment type 34046 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.chacon.com/conformity

Chacon S.A. – Avenue Mercator 2 1300 Wavre – Belgium Made in PRC

References

• Downloads
• Boutique des produits Chacon et Dio
• Shop for Chacon and Dio products
• Downloads
• Chacon

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>