SereneLife SLNKMSG90 Smart Neck Massager with Heat and Vibration Therapy User Manual

: June 13, 2024
: serenelife

Table of Contents

SereneLife SLNKMSG90 Smart Neck Massager with Heat and Vibration Therapy
Product Information
Product Introduction

SereneLife SLNKMSG90 Smart Neck Massager with Heat and Vibration Therapy

$SereneLife-SLNKMSG9-Smart-Neck-Massager-with-Heat-and-Vibration-Therapy-FIG- $2$$

Product Information

The SLNKMSG90 Smart Neck Massager with Heat & Vibration Therapy is a portable and rechargeable neck massager designed to provide relief and relaxation to the neck area. It features 6 massage modes, adjustable electric impulse intensity, vibration heating therapy, and a timer for customizable usage. The massager has a built-in rechargeable battery and can be operated with or without the included adaptor.

Product Features:

6 massage modes for versatile use
Adjustable electric impulse intensity (16 levels)
Vibration heating therapy for added comfort
Timer with adjustable intervals (5 to 30 minutes)
Rechargeable battery for cordless operation
Compact and portable design

Warnings:

Not suitable for use with a pacemaker
Avoid using near microwave ovens or other infrared emitting instruments
Pregnant women and cardiovascular patients should consult a doctor before use
Do not use while sleeping or showering
Not intended for use by children or individuals who cannot communicate
Avoid use if you have a skin sensitive or heat sensitive condition
Do not adjust modes while in use; turn off and restart instead
Increasing intensity does not enhance therapeutic effect
Do not dismantle or submerge in water for cleaning

Cleaning & Maintenance:

Use a soft, barely damp towel to clean
Store in a dry and well-ventilated place
Avoid direct sunlight and extremely hot humid places for storage

Usage Instructions:

To operate, set the operation switch to the ON position.
Moisten the neck piece and iron with a wet towel before use.
To select massage modes, press the up or down buttons to cycle through the six available modes.
To adjust the intensity of electrical impulses or vibration, use the up or down buttons to select the desired level.
To adjust the heating mode, use the left or right buttons to choose between high (H), low (L), or no heat (0).
To select electric impulse modes, use the left or right buttons to choose from the six available modes.
To select vibration modes, use the left or right buttons to choose from the six available modes, including auto vibration massage mode, vibration only, knead, beating, press & rolling.
To set the timer, use the left or right buttons to adjust the timer from 5 to 30 minutes with 5-minute intervals.
When the power is low, switch the ON/CHARGE button to CHARGE. The indicator will flash green while charging and remain solid green when fully charged. Charging takes approximately 3-4 hours.
It is recommended to use the neck massager twice per day for 15 minutes of vibration and electrical impulse massaging, along with 15 minutes of heat.

Product Introduction

This neck massage system has evolved from Chinese Meridian beliefs. Designed with the neck curve, the device adopts the benefits of low frequency electric therapy, magnetic therapy, far infrared therapy and vibration massage therapy to convert the high proficient energy elds to enter the deep issue fields of the body. It is important to maintain a correct position supplying a scientific platform to receive the maximum benefits from this therapy. This massage will stimulate the blood circulation and relax the regional muscles, eliminating inflammation, swelling, pains and fatigue, numbness, and headaches.

Product Specifications

Beautifully designed that incorporates the latest 3D intelligent fitting technology to easily adjust the electrodes according to your neck curve for more comfortable use.
Far infrared heating forms a high proficient compound energy field.
Use 2 levels of temperature settings for Far infrared heating
For the computerized program you can choose 6 therapy modes, 2 automatic and 4 manual modes according to personal need and prefference.
As for electronic impulse, use 6 kinds of compound therapy modes.
Use the 6 diﬀerent vibration massage modes according to personal need and preference.
Embedded health magnets will stimulate accupoints within the body, and thus balance the Yin & Yang of the body to improve micro-circulation.
Easily operates with remote and backlit LCD screen.

$SereneLife-SLNKMSG9-Smart-Neck-Massager-with-Heat-and-Vibration-Therapy-FIG- $3$$ $SereneLife- SLNKMSG9-Smart-Neck-Massager-with-Heat-and-Vibration-Therapy-FIG- $4$$

Operation Methods

Operation for Charging

Adaptor for charging
Plug the adaptor into the unit and into the power supply
Rechargeable supply (applicable for rechargeable type), When not using the adaptor, it could be operated with the embedded rechargeable batteries.

TO OPERATE

Set the operation switch to “ON” position.
Please use a wet towel to make the neck piece and iron barely moist. Wipe neck clean from perspiration. Then adhere the instrument to the neck.
Press the “ ” button to begin operation. Note the buzz and light indicates starting-up. The LCD on the remote displays status as it enters into automatic mode. (High heat, Multi function vibration, first vibration massage, timer on for 15 minutes) Simply press this “ ” button again to end use. When the remote and the massager are synchronized, one buzz will be heard.
Using the following Buttons: “ ” button for choosing modes upward, and ” ” button for choosing modes downward.
Using the following buttons:”< ” button for decrease “> ” button for increase
Conversion of modes.
Through “ ” & “ ” button to choose “ “, then press”< ” or ” >” to choose from six different modes noted as follows: 1-AUTO MODE which includes all of the following: vibration & heating, heating & electric impulse, heating, vibration, electric impulse auto circulate. 2-vibration & heating, 3-heating & electrical impulse, 4-heating, 5- vibration, 6-electrical impulse.
lnstensity Operate
Through “ ” & “ “button to choose the , then press or to convert the intensity of the electrical impulses (16 levels) or the vibration intensity (31evels).
Conversion of Heating Mode
Through “ ” & “ “button to choose the “ “, then press < or > to adjust heat to either high (H), low (L), or none (0).
Electric Impulse Modes
Through” ” & “ “button to choose the “ “, then press < or > to select from 6 impulse modes.
Vibration Modes
Through” ” & “ “button to choose the “ “, then press < or > to select from 6 vibration modes including auto vibration massage mode, vibration only, knead, beating, press & rolling.
Operation of Timer
Through” ” & “ “button to choose the “ “, then press < or > to adjust the timer from 5 to 30 minutes with 5 minute intervals.
Rechargeable Battery
Please charge it when the power is low. Just switch the “ON/CHARGE” button to “CHARGE”, and the indicator will be in green and ashing, when it stops ashing and keep in green, it means power has been fully recharged. It takes about 3-4 hours to make it be fully charged.
It is recommended to use this neck massager twice per day for 15 minutes of vibration and electrical impulse massaging and 15 minutes with heat

WARNINGS

Cannot be used with a PACEMAKER.
Do not use near microwave oven or other infrared emitting instruments.
Pregnant women and cardiovascular patients should consult a doctor before use.
Do not use when sleeping or showering.
Not for use by children or those who cannot communicate.
Not for use by those who have either a skin sensitive or heat sensitive condition.
Do not adjust modes of operation while in use. Turn it off and then restart.
An increased intensity of pressure or power or heat does not result in a more benecial therapeutic eect.
Do not dismantle the instrument in any way, and do not submerge in water or use water directly on instrument to clean.

Cleaning & Maintaining

Use a soft barely damp towel to clean.
Store in a dry, well ventilated place.
Do not store in direct sunlight, or in an extremely hot humid place

$SereneLife-SLNKMSG9-Smart-Neck-Massager-with-Heat-and-Vibration-Therapy-FIG- $10$$

PLEASE NOTE

At initial start-up, keep the infrared light emission window on the controller and the infrared light receiving window on the main unit directly opposite of each other, as shown by illustration above. This position is necessary for remote controller to operate. Each valid operation of the remote will ‘beep’ when starting.
Please charge it when the power is low . Just switch the “ON/CHARGE” button to “CHARGE”, and the indicator will be in green and ashing, when it stops ashing and keep in green, it means power has been fully recharged. It takes about 3-4 hours to make it be fully charged.
If the remote controller does not work when the main unit is charged and units are aligned at the proper position, please replace battery CR2032 in the remote. 8 9

Features