BLAUPUNKT BGx 4504 Powered Speaker Instruction Manual
- June 9, 2024
- Blaupunkt
Table of Contents
BLAUPUNKT BGx 4504 Powered Speaker
CAUTIONS
Proper system planning is vital in order to maximize the device’s performance
and road safety. Plan your installation carefully to avoid compromising
performance reliability of the system. Consult an authorized Blaupunkt dealer
for installation or preparation. Read the manual carefullt before operating
the device for the first time.
Safety Notes
Ensure to follow below safety notes during installation and wiring connection:
–
- Disconnect the negative terminal of the battery. Refer to the safety notes of the vehcle manufacturer.
- Ensure positions of the holes are nowhere near the vehicle component to avoid any damage during drilling.
- Ensure cross section of the cable is no less than 2.Smm2 if the positive and negative cables are too long.
- Incorrect installation may result in malfunction of the device or the car sound system.
Installation and Connection Instructions
- Select a dry and well-ventilated location to install the device.
- The device must not be installed in overly exposed location such on therear shelf, rear seat etc.
- The installation location must be suitable for screw holes and have stable ground support.
Disclaimer
In no event shall Blaupunkt be liable for any direct, indirect, punitive,
incidental, special consequential damages to property or life and whatsoever
arising out of or connected with the use or misuse of our products.
USA & CANADA: This product is not intended for sale in the United States and
Canada. If purchased in the U.S. or Canada, this product is purchased on as-is
basis. No warranty, whether expressed or implied is provided in the U.S. or
Canada.
Voltage Supply
- Use the supplied power extension cable to connect to the positive battery terminal.
- Firmly and carefully connect the ground lead to a bare metal point on the vehicle chassis.
- The control of the device should be a two-channel control, either via the preamplifier output of the car sound system.
- A control solely via the right or left channel is also possible since the low-frequency portion of the music is generally identical on both channels.
Disposal Notes
- Do not dispose of your old unit in the household trash!
- Use the return and collection systems available to dispose of the old device.
This manual may be updated from time to time without any notice. Visit www.blaupunkt.com for more info.
SPECIFICATION
BGx4404
Pair of 4.0″ 4-way quadaxial speaker with PP Injected Cone including mounting hardware
- Max. Power Handling : 45W
- Normal Output Power (RMS): 1 SW
- Impedance: 4ohms
- Frequency Response: 1 00Hz – 20,000Hz
- Sensitivity: 85dB
- Mounting Depth : 47mm
- Diameter Hole: 115mm
Accessories
BGx4504
Pair of 5.0″ 4-way quadaxial speaker with PP Injected Cone including mounting hardware
- Max. Power Handling : 60W
- Normal Output Power (RMS) : 20W
- Impedance: 4ohms
- Frequency Response: 90Hz – 20,000Hz
- Sensitivity: 85dB
- Mounting Depth: 51 mm
- Diameter Hole: 135.5mm
Accessories
BGx4604
Pair of 6.0″ 4-way quadaxial speaker with PP Injected Cone including mounting hardware
- Max. Power Handling : 90W
- Normal Output Power (RMS): 30W
- Impedance: 4ohms
- Frequency Response: 65Hz – 20,000Hz
- Sensitivity: 86dB
- Mounting Depth : 54mm
- Diameter Hole: 142mm
Accessories
BGx4695
Pair of 6.0″x 9.0″ 5-way pentaxial speaker with PP Injected Cone including mounting hardware
- Max. Power Handling: 120W
- Normal Output Power (RMS) : 40W
- I mpedance : 4ohms
- Frequency Response: 45Hz- 20,000Hz
- Sensitivity : 88dB
- Mounting Depth: 75.4mm
- Diameter Hole: 121x167mm
Accessories
INSTALLATION
WIRING DIAGRAM
TROUBLESHOOTING
If any of the following problem OcCur, please resort to Troubleshooting for the possible solutions. Consult Blaupunkt authorized dealer if problem persist.
| Problems | Possible Causes | Solutions |
|---|---|---|
| Speaker does not work | Incorrect or loose wiring connection. | En sure proper |
wiring connections of speaker.
Fraying or broken cables.| Repair or replace if the cables are damaged.
Speaker is damaged.| Replace with a new speaker.
Distorted and
h issing sound
| Voice coil or speaker cone is
damaged.
| Replace with a new speaker.
FOR MORE INFO
Documents / Resources
|
BLAUPUNKT BGx 4504 Powered
Speaker
[pdf] Instruction Manual
BGx 4504 Powered Speaker, Powered Speaker, BGx 4504 Speaker, Speaker, BGx 4504
---|---