CARVIN M50 Unidirectional Dynamic Microphone Instructions
- June 13, 2024
- CARVIN
Table of Contents
CARVIN ENGINEERING DATA
MODEL UNIDRIECTIONAL DYNAMIC MICROPHONE
INSTRUCTIONS
INTERNAL CONNECTIONS
UNIDRIECTIONAL DYNAMIC MICROPHONE
MODEL CM50
The Carvin M50 is a rugged unidirectional microphone with a highly effective built-in wind and “pop” filter. It is mostly suited for vocals but can also double as an insrument mic. We recommend this microphone to performers who work close to their mics, where high volumes can be obtained without distortion or explosive breath “pop’s”. An excellent choice for club ‘use, rock singers, or any vocalist requiring the best in vocal reproductions. Designed for high end studio recording and broadcast applications.
Microphone Features:
- Bright, clean sound. Especially good for announcing, narration and dialogue, vocal music, and rhythm pickups
- Wind and “pop” filter readily removable for cleaning or replacement
- Unusually effective cardioid pickup pattern to minimize background noise and undesirable effects of studio and location acoustics. Rear and side rejection uniform to very low frequencies and completely symmetrical about microphone axis
- Self-contained spherical filter to control explosive breath sounds (“pop”) and wind noise in outdoor locations
- Cartridge shock-mounted for protection and quiet operation
- On/Off switch
Polar Pattern
Cardioid — rotationally symmetrical about microphone axis, uniform with
frequency (see Figure 2)
INTERNAL CONNECTIONS
ARCHITECT’S SPECIFICATIONS
The microphone shat ri- mg coil (dynamic) type with o frequency response of 45 to 15,000 Hz. The unit shall have a cardioid polar characteristic. The cancellation at the sides shall be approximately 5 dB and the cancellation at the rear shall be 15 to 20 dB. The mrophone shod have o rating impedance of 300 ohms designed 6 600 chrnsprecmps The microphone connector shall be a 3-pin professional audio type designed to more with a XLR mole connector. The microphone shall be provided with o swivel adapter odjustable through 90° from vertical to horizontal. The adapter will mount on o stand having a 5/8″-27 thread. The overall dimensions of the microphone shall be 5.125″ (130 mm) in length and 2.080″ (53 mm) in diameter.
GUARANTEE
This Carvin product is guaranteed to be fret from electrical and mechanical defects for a period of one year from dote of purchase. Microphones dropped, misused or exposed to moisture are not covered under warranty Please retain prod of purchase date. This guarantee includes ports and labor This guarantee is in lieu of any and all other guarantees or warranties, express or implied, and there shall be no recovery for any consequential or incidental damages.
SHIPPING INSTRUCTIONS
Carefully repack the until, have it insured prepaid to:
Carvin
Service Deportment
12340 World Trade Drive
San Diego, CA 92128
MODEL CM50 UNIDIRECTIONAL. DYNAMIC MICROPHONE SPECS:
Type : Dynamic
Frequency Response : 50 to 15.000HZ
Output Level (at 1.000 Hz. 600 ohms): Open Circuit Voltage’ -72 dB. (0.19
mV)
Cable : M50 6 Om (20 ft) three-conductor shielded broadcast type with XLR
professional audio connector’
Case : Grey powder coat die casting and steel mesh grille
Swivel Adapter : Slip-in positive-action. adjustable from 0° to 90′. with
standard 516-27 thread
Net Weight : (less cable) 8.5 oz.
12340 World Tread Drive ,SAn Diego ,CA 92128
800.854.2235
carvin.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>