Sonoff RM433 Remote Controller User Manual
- June 6, 2024
- SonOFF
Table of Contents
Sonoff RM433 Remote Controller
Install batteries
The battery is not included, please purchase it separately.
Specifications
| Model | RM433R2 |
|---|---|
| RF | 433MHz |
| Remote controller size | 87x45x12mm |
| Remote controller Base size | 86x86x1 Smm(not included) |
| Power supply | 3V button cell x 1 (Battery model: CR2450) |
| Material | PCVO |
Product Introduction
The device applies to all SON OFF products with 433MHz frequency and other
devices supporting the 433MHz communication protocol.
Buttons are created with different functions when
pairing with different products.
Buttons Instructions
Example 1: iFan03 Wi-Fi Fan & Light Controller
Example 2: D1 Wi-Fi smart dimmer
Works with SON OFF devices
- RFR2
- RFR3
- 4CHPROR3
- SlampherR2
- D1 Wi-Fi smart dimmer
- TX series Wi-Fi smart switches
- iFan03 Wi-Fi Fan & Light Controller
Other devices supporting the 433MHz communication protocol
RM433R2-BASE
Installation methods 1
Install the base on the wall with 3M adhesive tapes.
Installation methods 2
Remove the two upper covers from both sides of the base to install with
screws.
The base is
not included into the package, please purchase it separately.
FCC Warning
Changes or modifications not expressly approved by the party responsible for
compliance could avoid the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference
- this device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Hereby, Shenzhen SonoffTechnologies Co., Ltd. declares that the radio equipment type RM433R2 is in compliance with Directive 2014/53/EU.The full text of the EU declaration of conformity is available at the following internet address:
https://sonaff.tech/usermanuals
Shenzhen SonoffTechnologies Co., Ltd.
1001, BLDGB, Lianhua Industrial Park, shenzhen, GD, China
ZIP code: 518000
Website: sonoff.tech