GLOBAL INDUSTRIAL 320776 5 Gallons Portable Sandblaster User Manual

GLOBAL INDUSTRIAL 320776 5 Gallons Portable Sandblaster

DANGER

• CHEMICALS SUCH AS LEAD ARE FOUND IN CORD AND SAND BLASTER. BE SURE TO WASH HANDS AFTER USE.
  ALWAYS WEAR PROTECTION AND RATED GEARS SUCH AS GLOVES, GOGGLES, AND MASK WHILE OPERATING SAND BLASTER.

• DO NOT OPERATE SAND BLASTER NEAR OR AROUND COMBUSTIBLE AND/OR FLAMMIBLE LIQUIDS, GASES, OILY RAGS, OR COMBUSTIVE MATERIAL. SPARKING CAN OCCUR WHILE SAND BLASTING, WHICH COULD RESULT IN FIRE OR EXPLOSIONS.•

• ENSURE OPERATOR IS GROUNDED AND WEARS PROPER ANTI-STATIC GEAR

NOTE

• INSPECT ITEM CAREFULLY FOR MISSING PARTS OR DAMAGE.
• DO NOT USE SANDBLASTER IF ANY PARTS ARE MISSING,BROKEN, OR DAMAGED
• INSPECT FITTINGS AND CONNECTIONS BEFORE OPERATING.
• ENSURE OPERATOR READS AND UNDERSTANDS MANUAL PRIOR TO OPERATION.
• CONDUCT NECESSARY MAINTANANCE TO SANDBLASTER WHEN REQUIRED.
• FOR OPTIMAL PERFORMACE, AVOID USING SANDBLASTER IN DAMP AND WET AREAS.
• KEEP CHILDREN AWAY FROM SANDBLASTER.
• DISCONNECT AIR COMPRESSOR WHEN SANDBLASTER IS NOT IN USE.

Part List

Assembly Instructions

1. Insert axle bracket (Ref 5) into both ends of the wheel axle (Ref 4). Ensure that fastening holes on axle bracket point outwards.
2. Insert cotter pin (Ref 1). washer (Ref 2), wheel (Ref 3), washer, and cotter pin in the order shown above. Assemble on both sides of the wheel axle.
3. Place tank (Ref 6) on the floor and lay axle bracket assembly on the fastening points. Fasten the bracket to tank with the M6 screw (Ref 8), washer (Ref 7), and nut (Ref 9).
4. Connect airhose (Ref 20) from tank to tee air manifold (Ref 18).
5. Attach U shaped handle (Ref 27) to axle bracket. Ensure push pins snap into place and lock handle.
6. Attach pneumatic connector (Ref 16) to filer (Ref 15).
7. Attach abrasive hose (Ref 20) to tank using hose clamp (Ref 29).
8. Connect blast gun (Ref 31) to connector hose.

Operating Instructions

Loading abrasive into tank

1. Ensure abrasive is dry.
2. Turn off air supply and read gauge until is reaches to zero pressure.
3. Insert funnel and pour abrasive into the tank. Never fill tank to full capacity. For multiple usages refill and keep tank to 3/4 full.
4. Close gasket and open air supply valve.
5. As you begin to pressure the tank, ensure that there are no air leaks throughout the assembly.

Operation

1. Keep operating air pressure between 60~125 PSI.
   DO NOT EXCEED 125 PSI.

2. Ensure that the abrasive material being used is compliant and operational with this item’s capabilities.

Maintenance

1. While operating, ensure sandblaster tank is not located in spray reach of spray nozzle.
2. Do not operate sandblaster if there are any air leaks in the air supply.
3. Regularly inspect sandblaster hose. During maintenance check, run compressor without any abrasive material. Running your hand down the hose, you should feel any air leaks and blisters. If you spot any sign of ware, replace hose immediately.

Troubleshooting Chart

Customer Service
US: 1-800-645-2986

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>