DWS312 Zigbee Door Window Sensor Instructions
- June 4, 2024
- zigbee
Table of Contents
DWS312 Zigbee Door Window Sensor
Function introduction
Product Data
Safety & Warnings
- This device contains button lithium batteries that shall be stored and disposed properly.
- DO NOT expose the device to moisture.
Product Description
The Zigbee Door Window sensor is a wireless, battery-powered contact sensor,
compatible with the Zigbee 3.0 standard. The device can be operated
intelligently via working with a Zigbee gateway to communicate with other
devices. It is a zigbee low-energy wireless door/window sensor that makes you
know the opening/closing status of door and window by separating the magnet
from the transmitter. Connect it with the gateway which supports automation
function and you can create a smart scene to trigger other devices.
Physical Installation
- Peel off the protective layer from the sticker on the sensor.
- Stick the sensor onto the door/window frame.
- Peel off the protective layer from the sticker on the magnet.
- Stick the magnet onto the moving part of the door/window, no further than 10mm from the sensor
Positioning of the Sensor and the magnet:
Correct positioning of the magnet in relation to the Sensor:(vertical line
marks should align)
Added the device to a Zigbee gateway
-
Step 1: From your ZigBee gateway or hub interface, choose to add device and enter Pairing mode as instructed by the gateway.
-
Step 2: Press and hold the Prog. button on the device for 5s until the LED indicator flashes three times, which means the device has entered the pairing mode, then the indicator will flash rapidly to indicate successful pairing.
Create a smart scene to trigger other devices
- From your ZigBee gateway or hub interface, go to automation setting page and create a smart scene to trigger other devices as instructed by the gateway.
Factory reset the device
- Press and hold the Prog. button on the device for 5s until the LED indicator flashes three times, which means the device is reset to factory default and then enter network pairing mode.