Joie Steadi R129 Enhanced Child Restraint Car Seat Instruction Manual
- June 3, 2024
- Joie
Table of Contents
Child height 40cm-105cm/
Child weight ≤ 18kg;
Steadi R129
enhanced child restraint
Instruction Manual
Steadi R129 Enhanced Child Restraint Car Seat
Welcome to Joie™
Congratulations on becoming part of the Joie family! We are so excited to be
part of your journey with your little one. While traveling with the Steadi™
R129 enhanced child restraint you are using a high quality, fully certified
safety enhanced child restraint. Please carefully read this manual and follow
each step to ensure a comfortable ride and best protection for your child.
To use this Joie enhanced child restraint with vehicle belt, your child must
meet the following requirements.
Rearward Facing: Child height 40cm-105cm/ max. 18kg;
Forward Facing: Child height 76cm-105cm/ max. 18kg;
Please Confirm
Please read all the instructions in this manual before installing and using
the product.
! IMPORTANT: KEEP FOR FUTURE REFERENCE. PLEASE READ CAREFULLY.
Please keep the instruction manual in the storage compartment of the rear
cover for future reference.
Parts List
Please make sure there are no missing parts. Please contact the retailer if anything is missing.
1 Head Support
2 Shoulder Strap Covers
3 Buckle
4 Crotch Strap Covers
5 Adjustment Adaptor
6 Adjustment Webbing
7 Shoulder Harness| 8 Lock-off Device
9 Safety-belt Slot
10 Infant Insert
11 Reclining Adjustment Handle
12 Head Support Adjustment Lever
13 Instruction Manual Storage Compartment
---|---
Accessory
Canopy
Accessories may be sold separately or may not be available depending on
region.
WARNING
! BE cautious that the rigid items and plastic parts of the enhanced child
restraint system shall be so located and installed that they are not liable to
become trapped by a movable seat or in the door of the vehicle.
! DO NOT use the rearward facing enhanced child restraint systems in seating
positions where there is an active frontal airbag installed.
! To use this enhanced child restraint according to the UN Regulation No.129,
your child must meet the following requirements.
! Rearward Facing: Child height 40cm -105cm / max. 18kg
! Forward Facing: Child height 76cm – 105cm / max. 18kg
! IMPORTANT – DO NOT USE FORWARD FACING BEFORE THE CHILD’S AGE EXCEEDS 15
MONTHS (Refer to instructions).
! The enhanced child restraint may not fit in all approved vehicles. Please
refer to the fitting list included for more details.
! Any straps holding the enhanced child restraint to the vehicle should be
tight, that any straps restraining the child should be adjusted to the child’s
body, and that straps should not be twisted.
! After your child is placed in this enhanced child restraint, the safety belt
must be used correctly. Ensure that any lap strap is worn low down, so that
the pelvis is firmly engaged, shall be stressed.
! This enhanced child restraint should be replaced when it has been subject to
violent stresses in an accident. An accident can cause damage to it that you
cannot see.
! Consider the danger of making any alterations or additions to the device
without approval of the adequate authority, and the danger of not following
closely to the installation instructions provided by the enhanced child
restraint manufacturer.
! Please keep this enhanced child restraint away from sunlight, otherwise it
may be too hot for child’s skin. Always touch the enhanced child restraint
before placing child in it.
! NEVER leave your child unattended with this enhanced child restraint.
! Any luggage or other objects liable to cause injuries in the event of a
collision shall be properly secured.
! The enhanced child restraint system shall NOT BE USED without the soft
goods.
! The soft goods should not be replaced with any other than the one
recommended by the manufacturer, because the soft goods constitutes an
integral part of the restraint performance.
! Please check if this enhanced child restraint can be installed properly in
your vehicle before you purchase it.
! NO enhanced child restraint can guarantee full protection from injury in an
accident. However, proper use of this enhanced child restraint will reduce the
risk of serious injury or death to your child.
! DO NOT install this enhanced child restraint without following the
instructions in this manual or you may put your child at serious risk of
injury or death.
! DO NOT use this enhanced child restraint if it has damaged or missing parts.
! DO NOT have your child in large/oversized clothes because this may prevent
your child from being, properly and securely fastened by the shoulder harness
straps and the crotch strap between the legs.
Emergency
In case of emergency or accidents, it is most important to have your child
taken care of with first aids and medical treatment immediately.
Product Information
- This is Universal Belted Enhanced Child Restraint System. It is approved according to UN Regulation No.129, for use primarily in “Universal seating positions” as indicated by vehicle manufacturers in the vehicle user’s manual.
- If in doubt, consult either the Enhanced Child Restraint System manufacturer or the retailer.
Choose the Installation Mode
Child’s Size| Installation Mode| Installation| Reference
Age
---|---|---|---
40cm-105cm/18kg <| Rear facing mode| | Approx 4 years
76cm-105cm/18kg<| Forward facing mode| | 15 months to approx 4 years
Important
When the child is suitable for both forward and rearward facing modes, it is
recommended to install this child restraint in the rearward facing mode as it
is relatively safer.
Concerns on Installation
see images 1 – 3
Height Adjustment for Head Support and Shoulder Harnesses
see images 4 – 6
! When used in rear facing mode, the shoulder harness height must be even with or just below the top of child’s shoulders. 4
! When used forward facing, the shoulder harness height must be even with the top of child’s shoulders. 5
- Please adjust the head support and shoulder harnesses to proper height according to the child’s height.
- Pull the head support adjustment lever 6 -1, meanwhile pull up or push down the head support until it snaps into one of the 6 positions. The head support positions are shown as 6
Recline Adjustment
see images 7 – 9
Using in the rear facing mode
(Child height 40cm-105cm/max. 18kg/infant – 4 years old)
see images 10 – 18
! Please install the child restraint on the vehicle seat, and then put the
child in the child restraint.
! The child restraint can not be used if the vehicle safety belt buckle
(female buckle end) is too long to anchor the child restraint securely. 10
-1
-
Fasten the belts in the a green safetybelt slots at the back of the body. 11
! Shoulder belt must pass through the safety-belt slot. -
Open the lock-off device and insert the safety belt through it. 12
-
While pressing the child restraint, pull the belts to fasten the child restraint tightly and securely.
! Please check by moving the child restraint back and forth.
! Shoulder belt passes through the safety-belt slots, as 13-1
! Shoulder belt passes through Lockoff Device, confirm the Lock-off Device is pushed down, as 13-1 -
To lengthen the shoulder harness belts, press the harness adjustment button while pulling out the shoulder harnesses to loosen. (grab the both two shoulder pads to pull). 14! We recommend using the full infant insert while the baby is under 60cm and can be used until they outgrow the infant insert. The infant insert increases side impact protection. 16
-
Place the child into the enhanced child restraint and pass both arms through the harnesses.
-
Engage the buckle until it clicks. 17
-
Pull down the adjustment webbing and adjust it to the proper length to make sure your child is properly secured. 18 ! Always keep child secured in harness and properly tightened by removing any slack.
Using in the forward facing
mode (Child height 76cm-105cm/max. 18kg/15 months – 4 years old)
see images 19- 22
! Please install the child restraint on the vehicle seat, and then put the
child in the child restraint.
! The vehicle buckle tongue is engaged with the buckle correctly, as 19
! The child restraint can not be used if the vehicle safety belt buckle
(female buckle end) is too long to anchor the child restraint securely.
19-1
! Shoulder belt passes through Lock-off Device and safety-belt slots, confirm the Lock-off Device is pushed down, as 20
! To lengthen the shoulder harness belts, press the harness adjustment button
while pulling out the shoulder harnesses to loosen. (grab the both two
shoulder pads to pull).
! Open the belt buckle by pressing firmly on the red button. 21 -1. place the
child in the seat and put the shoulder belts over the child’s shoulder. 21
! Remove the infant
insert when forward facing mode.
! Pull down the adjustment webbing and adjust it to the proper length so that
your child is snugly secured. 22
! Make sure the space between the child and the shoulder harness is about the
thickness of one hand.
Use Canopy
see images 23- 25
Detach Soft Goods
see images 26- 33
Press the red button to disengage the buckle. 26
Follow steps 27 – 33 to detach soft goods.
To re-attach the soft goods please repeat the above steps in the reverse
step.
Care and Maintenance
! Please wash the seat cover and inner padding with cold water under 30°C.
! Do not iron the soft goods.
! Do not bleach or dry clean the soft goods.
! Do not use undiluted detergents gasoline or other organic solvent to wash
the enhanced child restraint or base. It may cause damage to the enhanced
child restraint.
! Do not wring out the seat cover and inner padding to dry. It may leave the
seat cover and inner padding with wrinkles.
! Please hang dry the seat cover and inner padding in the shade.
! Please remove the enhanced child restraint and base from the vehicle seat if
not in use for a long period of time. Put the enhanced child restraint in a
cool, dry place where your child cannot access it.
! Do not tamper with the harness connectors during cleaning.
Allison GmbH
Adam-Opel-Straße 21 67227
Frankenthal
bribg the kids™
Share the joy at joiebaby.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>