Grace Company My Comfort Cutter 28mm Instructions

June 12, 2024
Grace Company

Grace Company My Comfort Cutter 28mm Instructions
My Comfort Cutter

Pairs with TrueCut rulers for clean, straight cuts!
Product Parts

Included Parts

(Some parts pre-assembled)

  • Ergo-Handle TC-09-1598
    Ergo-Handle

  • Nut TC-05-1597

  • Spring TC-03-1243

  • Plastic Washer TC-05-1236
    Plastic Washer

  • Blade Guard TC-05-1239

  • 28 mm Blade TC-08-1101
    Bolt

  • Ruler Guide TC-05-1241

  • Guide Bolt TC-05-1596

  • Bolt TC-03-1556

  • Plastic Insert TC-05-1240

My Comfort Cutter

Components
The cutter can be set up with or without the ruler guide and for right or left-handed use.
Components

Pictured: Right-handed
configuration using ruler guide.
Left-handed

Pictured: Left-handed
configuration without ruler guide.

Changing the Blade

Take the following steps to change the blade on the cutter

  1. Remove the plastic nut, spring, and plastic washer.
    Changing the Blade

  2. Push on the end of the bolt to remove the bolt, blade, and ruler guide.
    Push On The End

  3. Reinstall the bolt and ruler guide with a new or sharpened blade
    Reinstall The Bolt

  4. Reinstall the plastic nut, spring, and plastic washer.
    Reinstall The Nut

Swapping Hands

Take the following steps to switch the cutter from right-handed to left- handed.

  1. Remove the plastic nut, spring, and plastic washer
    Changing the Blade

  2. Push on the end of the bolt to remove the bolt, blade, and ruler guide
    Remove The Plastic
    Swapping Hands Continued

  3. Remove the safety guard by pushing it back and then pulling it out.
    Remove The  Safety Guard

  4. Remove the right handle base by pulling it out.
    Remove The Right Handle

  5. Install the right handle base on the left side of the cutter.
    Install The Right Handle

  6. Reinstall the safety guard on the right side of the cutter by inserting it at an angle and then pulling it out.
    Reinstall The Safety Guard

  7. Reinstall the bolt, blade, and ruler guide so that they are on the right side of the cutter
    Reinstall The Bolt

  8. Reinstall the nut, spring, and washer so that they are on the left side of the cutter and tighten to hold in place.
    Reinstall The Nut

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals