JLAB True Wireless JBUDS AIR Sport User Guide
- June 3, 2024
- JLab
Table of Contents
JLAB True Wireless JBUDS AIR Sport
FIRST TIME SETUP
AUTO-CONNECTING EARBUDS
- A. Take earbuds out of the charging case and remove stickers.
- B. Press and hold both touch sensors 3+ seconds to turn ON. One earbud turns solid white and the other earbud blinks blue/white indicating ready to pair to your device.
CONNECTING BLUETOOTH
- Select “JLab JBuds Air Sport” in your device settings. Voice prompt
- “Bluetooth connected” followed by solid white lights will indicate you are connected.
ADDING NEW/ADDITIONAL BLUETOOTH DEVICES:
- Turn OFF Bluetooth from any previously connected device. Turn ON Bluetooth from new device. Take earbuds out of the case. Earbuds will automatically enter
- Bluetooth Pairing. Select “JLab JBuds Air Sport” in new device settings to connect.
BUTTON FUNCTIONS
TURN OFF EARBUDS WITHOUT CHARGING CASE:
- Enter your Bluetooth device settings and disconnect the JBuds Air Spot.
- Earbuds will power OFF after 3 minutes.
EQ SETTINGS : Voice prompts will indicate EQ settings.
CHARGING EARBUDS
- Placing the earbuds in the charging case will power OFF earbuds and start charging. Blue lights indicate earbuds are charging and will turn OFF when fully charged.
- When earbuds are taken out of the case, they will auto power ON and reconnect to your device
CHARGING CASE
VoICE PROMPTS
- “JLab ON”: Power ON
- “Ready to Pair”: JBuds Air Sport are ready to pair to Bluetooth device
- “Bluetooth Connected”: Earbud is connected to device
- “Battery Full”: 100-75%
- Battery Medium”: 75-25%
- “Low Battery”: Less than 25%
- When power decreases to 10%,
- “Low Battery” will play
- “Goodbye”: Power OFF
FITTING
QUICK TIPS
- Fully dry off the earbuds before putting in the charging case.
- The left or right earbud can be used independently for music and phone calls.
- Simply choose one and take out of the case to connect.
- Choosing the correct ear tip makes a significant improvement in audio quality due to the proper seal for the driver. Test all ear tips for best results.
- Only ONE Bluetooth device can be connected at a time. Turn off Bluetooth on unwanted devices and turn on Bluetooth on chosen device to connect.
For full User Manual and troubleshooting, please visit INTL.JLAB.COM
MULTIPOINT
(connect 2 devices simultaneously)
- Once FIRST device is connected, turn off Bluetooth in device settings. JBuds Air Sport will auto enter Bluetooth Pairing.
- Enter your SECOND device Bluetooth settings and connect to JBuds Air Sport.
- Enter your FIRST device Bluetooth settings. Turn on Bluetooth and connect to JBuds Air Sport.
TROUBLESHOOTING
No audio in left earbud or earbuds disconnected from each other (Manual Reset)
- Enter your Bluetooth device settings and forget the JBuds Air Sport. Fig A
- Open the charging case door and leave both earbuds inside. Starting with ONE earbud, quickly tap the touch sensor 7x times. Light will blink blue 4x times. Leave the earbuds in the charging case. Fig C
- Repeat with the other earbud. Quickly tap the touch sensor 7x times. Light will blink blue 4x times. Fig c2
- Take both earbuds out of the charging case and keep them within 2 inches from each other. Wait for one to turn solid white and the other to blink blue/white. You are now ready to pair to your Bluetooth device.
Bluetooth device does not connect/reconnect
- Enter your Bluetooth device settings and forget the JBuds Air Sport. Fig A
- Turn OFF then ON Bluetooth. Fig B
- Take the earbuds out of the case. Wait for one to turn solid white and the other to blink blue/white.
- Select “JLab JBuds Air Sport” in device settings to reconnect.
Instructional videos at:
INTLJLAB.COM/MANUALS
3 MONTHS FREE With purchase. Visit
intl.jlab.com/tidal
- Shop products
- Product alerts
- Burn-in your headphones
FCC Information
FCC ID: 2AHYV-JBSPORT3L
FCC ID: 2AHYV-JBSPORT3R
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against hamful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, it not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that intererence will not OCCur in a particular installation. F this equipment does cause hamful interference to radio or television reception, which can be determined by Turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the followirng measures:
- Reorient or relocate the receiVIng antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that tO which the receiver Is Connected.
- Consult the dealer or an experienced radio/Iv technician for help.
If you cannot eliminate the interterence, the FCC requires that you stop using
your product.
Changes or modiications not expressly by the party responsIDle Tor compliance
could void the user’S authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
EU Compliance
PEAG LLC dba JLab hereby declares that this device is in compliance with the
essential requirements and other relevant provisions of the RED directive.
A copy of the EU Declaration of Conformity is available at
intl.jlab.com/compliance PEAG, LLC dba JLab Keizersgracht 482(C/O: E.O.Dike)
Unit #104, Amsterdam, 1017 EG Netherlands JLab 2281 Las Palmas Drive, Suite
101, Carlsbad, CA 92011, USA
This symbol indicates that this product and/or battery should not be disposed
of with household waste. When you decide to dispose of this product and/or its
battery, do so in accordance with local environmental laws and guidelines.
Battery Caution & Disposal Information
- Please take care of your battery. Do not, disassemble, burn, puncture, crush or bend your battery.
- Improper operation of the battery may product smoke. In such an event, ventilate the area.
- Extinguish any flames with carbon dioxide, dry-powder fire extinguisher, or cover with sand or mud.
- Take care to avoid conditions of excesSive moisture for prolonged periods and do not immerse.
- Do not expose to temperatures above 50°C/122°F. Charge battery fully before storage or if stored for longer than three months.
Disposal
At the end of its life, please take care to dispose of this product
responsibly, Electronic products and batteries contain materials that can be
harmful to the environment. Please do not dispose to unsorted waste. Take your
electronic waste to a designated collection or recycling facility to be
recycled properly. Your local council authority will be able to tell you where
your nearest facilities are. There may be one at your local supermarket.
JLab can help you recycle. Learn more intl-jlab.com/recycle
This product can be used in Europe without restrictions frequency bands: 2402Mhz-2480Mhz , maximum output power: s 10dBm
Address: GuangDong Simpreal Intelligent Techrnology Co., Ltd. Room 2408,
JiaHong ZhenXing DaSha, DongGuan Avenue #13, DongCheng District, DongGuan
City, Guang Dong Province, PR. China
Model: JBuds Air Sport
Contact Us
If you’re unsatisfied with your purchase, please contact us and we’ll take care of you! You can contact Our US based customer support team
Website : intl.jlab.com/contact
Email : [email protected]
Phone U.S.: +1 405-445-7219 (Check
hours intl.jlab.com/hours)
Phone U.K./EU: +44 20 8142 9361 (Check hours
intl.jlab.com/hours)
Visit intl.jlab.com/warranty to initiate
a return or exchange.
Access the full product manual at
intl.jlab.com/manuals
OFFICIAL AUDIO PARTNER OF MAJOR LEAGUE SocCER
- PROJECT JBuds Air Sport Wireless QSG
- STOCK: 220g, MATTE
- INK: 4/4 CMYK/ CMYK
- FLAT SIZE : 13.5433″ x 4.7244″
- FOLDED SIZE : 3.3858″ x 4.7244″