PR-45563-HPHNL Pressure Injectable Arrowg+ard Blue Advance Instruction Manual
- June 4, 2024
- Arrow
Table of Contents
PR-45563-HPHNL Pressure Injectable Arrowg+ard Blue Advance
Contents
- Three Lumen TaperFree® Catheter with Arrowg+ard Blue Advance® Antimicrobial/Antithrombogenic
- Protection1: 6 Fr. (2.11 mm OD) x 55 cm, Pressure Injectable, Blue FlexTip®
- GlideThru™ Peel-Away Sheath: 6 Fr. x 4″ (10 cm) Radiopaque over 6 Fr. Dilator
- Spring-Wire Guide, Nitinol, Marked: .018″ (0.46 mm) dia. x 17-3/4″ (45 cm) (Straight Soft Tip on One End – Straight Stiff Tip on Other)
- Guidewire, Marked: .018″ (0.46 mm) dia. x 130 cm Hydrophilic-Coated Nitinol with Soft Tip Tungsten Coil
- Introducer Needle: Echogenic 21 Ga. x 2-3/4″ (7 cm) TW
- Syringe: 10 mL Luer-Lock
- Skin Protectant Prep
- Dust Cap: Non-Vented
- SecondSite™ Adjustable Hub: Fastener
- SecondSite™ Adjustable Hub: Catheter Clamp
- Catheter Trimmer
- Safety Scalpel: #11
- Patient ID Card
- Chart Sticker
- Patient Information Booklet
- Checklist/CLIP Sheet
- Paper Tape Measure
- Dressing: STATLOCK®2 Catheter Stabilization Device
- Licensed under US Patent No. 7,329,412.
Warning:
Read all package insert warnings, precautions, and instructions prior to
use. Failure to do so may result in severe patient injury or death.
www.teleflex.com/IFU
WARNING:
Cancer and Reproductive Harm.
www.P65Warnings.ca.gov
Not made with natural rubber latex.Store below 25°C (77°F). Avoid excessive
heat above 30°C (86°F). Fluid path components are non-pyrogenic.
Contraindications:
The Pressure Injectable Arrowg+ard Blue Advance antimicrobial/antithrombin
biogenic catheter is contraindicated:
- for patients with known hypersensitivity to chlorhexidine
- in the presence of device-related infection in the intended insertion vessel or catheter pathway
- in the presence of thrombosis in the intended insertion vessel or catheter pathway
- Priming volumes are approximate and are done without accessories.
- Flow rate values are approximate and are determined using deionized water at 100 cm head height.
- Pump flow rates are determined at a maximum pump pressure of 10 psig and represent approximate flow capabilities.
- Pressure injection flow rates are determined at the injector pressure setting of 300 psi maximum using media of 11.8 centipoise viscosity, with 152 cm pressure tubing.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>