PR-45541-HP Pressure Injectable Arrowg+ard Blue Advance One-Lumen PICC Antimicrobial Instruction Manual
- June 3, 2024
- Arrow
Table of Contents
PR-45541-HP Pressure Injectable Arrowg+ard Blue Advance One-Lumen PICC
Antimicrobial
Contents
- 1: One Lumen TaperFree® Catheter with Arrowg+ard Blue Advance® Antimicrobial/ Antithrombogenic Protection1: 4.5 Fr. (1.58 mm OD) x 55 cm, Pressure Injectable, Blue FlexTip®
- 1: GlideThru™ Peel-Away Sheath: 5 Fr. x 4″ (10 cm) Radiopaque over 5 Fr. Dilator
- 1: Spring-Wire Guide: .018″ (0.46 mm) dia. x 17-3/4″ (45 cm) (Straight Soft Tip on Both Ends)
- 1: Introducer Needle: Echogenic 21 Ga. x 2-3/4″ (7 cm) TW
- 1: Syringe: 5 mL Luer-Lock
- 1: Skin Protectant Prep
- 1: Dust Cap: Non-Vented
- 1: SecondSite™ Adjustable Hub: Catheter Clamp
- 1: SecondSite™ Adjustable Hub: Fastener
- 1: Patient ID Card
- 1: Chart Sticker
- 1: Patient Information Booklet
- 1: Checklist/CLIP Sheet
- 1: Paper Tape Measure
- 1: Dressing: STATLOCK®2 Catheter Stabilization Device
- 1Licensed under US Patent No. 7,329,412.
- 2A registered trademark of C. R. Bard, Inc.
Rx only
Warning: Read all package insert warnings, precautions, and instructions prior to use. Failure to do so may result in severe patient injury or death. www.teleflex.com/IFU California Prop. 65
WARNING: Cancer and Reproductive Harm. www.P65Warnings.ca.gov Not made with natural rubber latex. Store below 25°C (77°F). Avoid excessive heat above 30°C (86°F). Fluid path components are non-pyrogenic.
Contraindications: The Pressure Injectable Arrowg+ard Blue Advance antimicrobial/ anti-thrombogenic catheter is contraindicated:
- for patients with known hypersensitivity to chlorhexidine
- in the presence of device related infection in the intended insertion vessel or catheter pathway
- in the presence of thrombosis in the intended insertion vessel or catheter pathway
- Priming volumes are approximate and are done without accessories.
- Flow rate values are approximate and are determined using deionized water at 100 cm head0 height.
- Pump flow rates are determined at maximum pump pressure of 10 psig and represent approximate flow capabilities.
- Pressure injection flow rates are determined at the injector pressure setting of 300 psi maximum using media of 11.8 centipoise viscosity, with 152 cm pressure tubing.
Arrow International LLC Subsidiary of Teleflex Incorporated 3015 Carrington Mill Blvd. Morrisville, NC 27560 USA
- www.teleflex.com
- LBLO57483 RO0 (2021-08)
Pressure Injectable Arrowg+ard Blue Advance® One-Lumen PICC
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>