PR-45552-HPHNM Pressure Injectable Arrowg+ard Blue Advance Two-Lumen PICC with 80 cm Hydrophilic-Coated Nitinol Guidewire Instruction Manual
- June 3, 2024
- Arrow
Table of Contents
PR-45552-HPHNM Pressure Injectable Arrowg+ard Blue Advance Two-Lumen PICC
with 80 cm Hydrophilic-Coated Nitinol Guidewire
Contents
- 1: Two Lumen TaperFree® Catheter with Arrowg+ard Blue Advance® Antimicrobial/Antithrombogenic Protection1: 5.5 Fr. (1.88 mm OD) x 55 cm, Pressure Injectable, Blue FlexTip®
- 1: GlideThru™ Peel-Away Sheath: 5.5 Fr. x 4″ (10 cm) Radiopaque over 5.5 Fr. Dilator
- 1: Spring-Wire Guide, Nitinol, Marked: .018″ (0.46 mm) dia. x 17-3/4″ (45 cm) (Straight Soft Tip on One End – Straight Stiff Tip on Other)
- 1: Guidewire, Marked: .018″ (0.46 mm) dia. x 80 cm Hydrophilic-Coated Nitinol with Soft Tip Tungsten Coil (CE 0120)
- 1: Introducer Needle: Echogenic 21 Ga. x 2-3/4″ (7 cm) TW
- 1: Syringe: 10 mL Luer-Lock
- 1: Skin Protectant Prep
- 2: Dust Cap: Non-Vented
- 1: SecondSite™ Adjustable Hub: Fastener
- 1: SecondSite™ Adjustable Hub: Catheter Clamp
- 1: Catheter Trimmer
- 1: Safety Scalpel: #11
- 1: Patient ID Card
- 1: Chart Sticker
- 1: Patient Information Booklet
- 1: Checklist/CLIP Sheet
- 1: Paper Tape Measure
- 1: Dressing: STATLOCK®2 Catheter Stabilization Device
- 1Licensed under US Patent No. 7,329,412.
- 2A registered trademark of C. R. Bard, Inc.
Warning:
Read all package insert warnings, precautions, and instructions prior to use.
Failure to do so may results in severe patient injury or death.
www.teleflex.com/IFU. California Prop. 65
WARNING:
Cancer and Reproductive Harm.
www.P65Warnings.ca.gov.
Not made with natural rubber latex
- Store below 25°C (77°F). Avoid excessive heat above 30°C (86°F).
- Fluid path components are non-pyrogenic.
Contraindications
The Pressure Injectable Arrowg+ard Blue Advance antimicrobial/antithrombogenic catheter is contraindicated:
- for patients with known hypersensitivity to chlorhexidine
- in the presence of device-related infection in the intended insertion vessel or catheter pathway
- in the presence of thrombosis in the intended insertion vessel or catheter pathway
Priming volumes are approximate and are done without accessories
- Flow rate values are approximate and are determined using deionized water at 100 cm head height.
- Pump flow rates are determined at a maximum pump pressure of 10 psig and represent approximate flow capabilities.
Pressure injection flow rates are determined at the injector pressure setting of 300 psi maximum using media of 11.8 centipoise viscosity, with 152 cm pressure tubing.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>