Eldom GDS6 Yaga Cloth Shaver User Manual

Eldom GDS6 Yaga Cloth Shaver User Manual

SAFETY INSTRUCTIONS

Before first use familiarizing yourself with the entire content of this manual

1. the unit must be plugged into the network with parameters of the current the same as the parameters on the casing

2. The appliance must be unplugged by pulling the plug instead of the supply cord

3. Do not merge the unit in water when cleaning it

4. The unit is designed to operate in a household, do not use the unit for purposes other than those enumerated in the manual

5. The device can be used by children aged 8 and older and by persons with limited physical, sensory, or mental capabilities, or persons without sufficient experience and knowledge only under the supervision or if previously instructed on the safe use of the appliance and the possible risks. Children shall not play with the appliance.

6. Cleaning and maintenance which is the responsibility of the user shall not be carried out by children without supervision.

7. Protect the appliance and the power cord against children
   under 8 years old. 6. use only genuine accessories 7. The unit may be repaired by a manufacturer’s authorized service center only.

8. All modifications or use of non-original spare parts or any other elements are prohibited and make use of the unit hazardous

9. regularly check whether the unit or part of it is damaged in any manner. Do not switch the unit if any damages are found.

10. in case the power cord is damaged it must be replaced by the manufacturer’s authorized service center.

GENERAL DESCRIPTION

1. Height adjuster
2. Shield
3. Blade
4. Body
5. Lamp
6. ON/OFF switch
7. Handle
8. Supply socket
9. Container
10. Little brush
11. Battery cover

TECHNICAL DATA

• power: 3W
• voltage supply: 100-240V ~ 50Hz
• battery: 2 x Ni-MH 600mAh
• loading time: 8 hours

INTENDED USE
The GDS6 shaver is designed to refresh various types of clothing and fabrics. Removing so-called flocs or fuzz from the material makes it look fresh again. The device can be used not only on clothes but also on curtains, blankets, or upholstered furniture. The distance pad with adjustable cutting length allows you to safely remove flocs without worrying that the refreshed material will be damaged.

HOW TO USE THE APPLIANCE

• The appliance can be used after charging the battery or by connecting to the mains
• The power cable should be properly connected to the socket (8).
• The appliance is equipped with an internal battery. Charging time is about 8 hours.
• To increase the battery life span charging should be done in one uninterrupted cycle after fully discharging.
• Charge is indicated by a control light (5). The indicator light does not turn off when the battery is charged.
• After charging, the appliance should be disconnected from the mains and the power cord should be unplugged from the socket (8).

BATTERY REPLACEMENT

1. Open the battery case.
2. Take out the used battery
3. Install a new battery by putting one side of the battery beneath the battery baffle and then pressing down the other side.
4. Used batteries should be thrown away the containers specially designed for this purpose

HANDLING

• before start-up fix a shield (2).

• Do not switch on the shaver when the shield is loose.
  Note. The appliance does not operate in case the shield is fixed improperly.

• The shaver starts the operation after the switch (6) has been slid into the „1” position.

• move the shaver along clothes lying on a flat surface

• To switch a unit off slide the switch (6) into the „0” position.

SPACER ATTACHMENT
For delicate fabrics or long-hair fabrics, put the spacer attachment over the cover (2) – Fig. 1. The distance between the attachment and the cover can be adjusted – Fig. 2.

GUIDELINES

1. Do not shave clothes in case clothes are on a body. It may cause wounds on the body.
2. When shaving clothes pay special attention to:
   • areas around buttons and zips
   • protruding parts
   • connections – sews
   • object glued to clothes
   • delicate parts
3. Before use try the unit on a hidden part of a cloth.
4. Move the unit acc. to a pattern on a cloth.
5. If required move the unit – vertically and horizontally
6. In the case of ‘flat ‘materials lay two layers of cloth and shave them on an iron board.
7. Do not switch the unit on when it is unnecessary, it may result in reduced life of the shield and the blade.

MAINTENANCE AND CLEANING

When the container is approx. 80% full clean it and internal blades as well. Before cleaning unplug the unit and switch it off.

• do not merge the unit into the water
• to not use abrasive or other damaging cleaning agents
• clean the casing with a wet cloth
• remove the casing (2) twisting it counterclockwise
• remove the blade (3)
• using a little brush (10) to clean the casing, blade, and the drive mechanism
• empty the container (9)
• Be careful then removing and cleaning the blade (3) since it is sharp.
• Be gentle when cleaning the metallic foil of the casing (2). Do not press it.

ENVIRONMENT PROTECTION

• the unit is made of materials that may be reused or recycled
• it must be provided to a relevant point specializing in collecting and recycling electric and electronic appliances.

Download PDF:Eldom GDS6 Yaga Cloth Shaver User Manual

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>