be quiet Pure Rock LP CPU Cooler User Manual

: June 3, 2024
: be quiet

Table of Contents

be quiet Pure Rock LP CPU Cooler
Introduction
SCOPE OF DELIVERY
The following parts are needed for this
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

be quiet Pure Rock LP CPU Cooler

be-quiet-Pure-Rock-LP-CPU-Cooler-User-Manual-product

Product information for this CPU cooler

Introduction

Thank you for deciding to purchase a be quiet! product. The following instructions will guide you through the installation process. If you do encounter installation problems, please don’t hesitate to contact our customer services by mailing service@bequiet.com. Please note that be quiet! cannot accept liability for damage caused by compatibility problems.

Warranty

3-year manufacturer guarantee for consumers (original purchase from authorized be quiet! dealers only)
Guarantee work can only be processed with a copy included of the purchase receipt from an authorized be quiet! dealer
Manipulation and structural changes of any kind, including any damage caused by external mechanical force, will lead to a complete voiding of the guarantee
Our General Warranty Conditions apply, which can be viewed on bequiet.com

Listen GmbH
Wilhelm-Bergner-Straße 11c . 21509 Glinde. Germany For further information contact us via e-mail: service@bequiet.com We recommend preparatory mounting of the cooler outside the PC case for subsequent installation.

SCOPE OF DELIVERY

be-quiet-Pure-Rock-LP-CPU-Cooler-User-Manual-
fig-1

The following parts are needed for this
1x Pure Rock LP CPU cooler (1), 2x Intel mounting brackets (2), 4x Intel fastening screws (4), 4x M3x3 screws (6), 4x Hexagonal nuts with sleeve (7), 4x Hexagonal nuts (8), 1x Hexagonal wrench (9)

Assembly of the mounting brackets Inserts the hexagonal nut with a sleeve from above through each Intel mounting bracket and screw together from below with the hexagonal nuts. Use the hexagonal wrench for this.
Removal of protective covering The underneath of the cooler must be removed prior to installation against the CPU.
Caution: The pre-applied thermal paste is not suitable for human consumption. If swallowed, drink lots of water and urgently seek medical attention. Keep it out of the reach of children. Avoid contact with skin and eyes.
Installation of the mounting brackets Attaches the 2 Intel mounting brackets to the underside of the CPU cooler using the M3x3 screws.
Mounting the CPU cooler Next place the cooler unit onto the CPU and then screw it alternatively tight from the backside of the mainboard. We recom- mend placing the cooler with the main-board on the table so it can be screwed from the backside. Connect the fan to the PWM signal of the motherboard.

The following parts are needed for this

1x Pure Rock LP CPU cooler (1), 2x AMD mounting brackets (3), 4x AMD backplate screws (5), 4x M3x3 screws (6)

Removal of AMD retention module To permit mounting of the cooler please remove both the plastic retainers of the AMD retention module. The factory-fitted backplate affixed to the rear side of the motherboard will be needed for the subsequent installation of the cooler.
Removal of protective covering The underneath of the cooler must be removed prior to installation against the CPU.
Caution: The pre-applied thermal paste is not suitable for human consumption. If swallowed, drink lots of water and urgently seek medical attention. Keep it out of the reach of children. Avoid contact with skin and eyes.
Installation of the mounting brackets Attaches the 2 AMD mounting brackets to the underside of the CPU cooler using the M3x3 screws.
Mounting the backplate Place the cooler unit onto the CPU and screw it from the rear side of the motherboard through the backplate alternately tight. We recommend placing the cooler with the mainboard on the table so that it can be screwed from the rear side. Next, connect the fan to the PWM signal of the motherboard.