Cell2 HALO-BLITZ Halo Ring 6LED Warning Lighthead User Manual

Cell2 HALO-BLITZ Halo Ring 6LED Warning Lighthead

6LED WARNING LIGHTHEAD W/ HALO-RING™

WIRING

OPERATION

For Warning Synchronization:
Connect YELLOW wires of all light heads together for synchronization.(All light heads should be set to the same Flash Pattern)

For Simultaneous or Alternating Warning Flash:

1. Apply +VDC to RED (or WHITE) and YELLOW wires simultaneously to enter Grouping Mode; light head will display short (single or double) flashes:
   • Single flash = Group1
   • Double flash = Group2
2. Remove YELLOW wire from +VDC then momentarily apply +VDC to YELLOW wire again to change Groups:
   • Light heads of the same Group will flash together.
   • Light heads of the different Group will flash alternately.
3. Save and Exit Grouping Mode by powering off the light head.

For changing Warning Flash Pattern: Momentarily apply +VDC to YELLOW wire:

• Once to next pattern
• Quickly three times to reset to FP#1

Warning Flash Patterns

1| Double [R65]| 8| Quad [SAE]
2| Single [2Hz]| 9| Quint [SAE]
3| Triple [2Hz]| 10| Mega
4| Quad [2Hz]| 11| Ultra [SAE]
5| Random| 12| Single-Quad
6| Single [SAE/CA13]| 13| Single H/L
7| Double [SAE]| 14| Steady

Note:

• All approvals based on actual model ordered.
• This product may not be factory-set at FP#1.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>