Keeson RF408A Remote Control User Guide
- June 3, 2024
- KEESON
Table of Contents
Keeson RF408A Remote Control
INSTALLATION INSTRUCTIONS
Item
-
PLAY /PAUSE button 1
Press the PLAY /PAUSE button to play or pause the audio device. -
Sync button 2
Press Sync button to active the model of the audio device, between Sync and Async model. -
Timer 3
Press the Timer button to set the active time of the audio device. -
Volume + 4
Press the volume + button to increace the volume of the audio device. -
Volume 5
Press the volume button to decreace the volume of the audio device. -
Power 6
Press the power button to open and shut the light. -
Morning 7
Press the morning button to set the light into morning model. -
Evening 8
Press the morning button to set the light into Evening model. -
Brightness + 9
Press the volume + button to increace the brightness of the light. -
Brightness 10
Press the volume button to decreace the brightness of the light. -
Timer 11
Press the Timer button to set the active time of the light.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: ( this device may not cause harmful interference, and ( this device must accept any interference received, including interference that m ay cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could v oid the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits f or a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy a nd, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee th at interference will not occur in a particular
installation. If this equipment does cause harmful in t erference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
ISED Statement
This device complies with Industry Canada license exempt RSS standard(s).
Operation is subject to the following two conditions: ( This device may not
cause interference, and ( This device must accept any interference, including
interference that may cause undesired operation of the device. This radio
transmitter (ISED certification number : 22406 RF408A ) has been approved by
Indust ry Canada to operate with the antenna types listed with the maximum
permissible gain indicated. Antenna types not included in this list, having a
gain greater than the maximum gain indicated for that type, are strictly
prohibited for use with this device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>