VISUAL COMFORT JN 5301 Alberto Small Open Cage Lantern Instruction Manual
- June 12, 2024
- VISUAL COMFORT
Table of Contents
ASSEMBLY INSTRUCTIONS
JN 5301 Alberto Small Open Cage Lantern
Alberto Small Open Cage Lantern
Item # JN 5301
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and contents
carefully. If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
| Phillips Screwdriver | Slotted Screwdriver | Chain Pliers |
|---|---|---|
| Slip Joint Pliers | Measuring Tape | Wire Cutters |
| Wire Strippers |
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove collar loop ( D ) from chain ( H ) by removing quick link ( E ).
-
Install mounting plate ( B) to the junction box and secure with mounting screws ( C ).
-
Secure collar loop ( D ) to mounting plate ( B ) using pliers to tighten locknut.
-
Install canopy ( F ) to collar loop ( D ) and secure with collar ring ( G ).
-
Determine desired overall length, and amount of chain (H) needed.
Shorten chain using chain pliers. (Keep extra chain) -
Attach chain ( H ) to collar loop ( D ) and fixture loop ( I ) using quick links ( E ). Secure quick links ( E ).
-
Feed wires through hole in frame, then hang cluster ( K ) to hook ( J ) on fixture frame.
-
Thread fixture wire and ground wire through chain (H).
NOTE: When you reach the collar loop ( D ), ensure there is no tension on the wires. Cut excess wires, being sure to leave enough to reach the junction box. -
Separate two sides of molded wire, and strip insulation on each 5/8″.
-
Loosen collar ring ( G ) and let canopy ( F ) slip down chain ( H ) carefully.
-
Twist all fixture wires together. Slip through center hole of collar loop ( D ).
NOTE: Untwist wires and separate to prepare for connection.