Keeson Technology RF396E Remote Control User Manual
- June 3, 2024
- Keeson Technology
Table of Contents
Technology RF396E Remote Control
User Manual
RF396E Remote Control
Item
1.1 Child Lock 1
Click the Child Lock button for 3 second to lock or unlock the remote.
1.2 Bedlam 2
Click the bed lamp button to open or shut the light under the bed.
1.3 Anti Snore 3
Click the Anti Snore button, the bed moves to Anti Snore position, press and
hold Anti Snore button for 5s, until backlight flashes, the control set the
current position as Anti Snore position
14TV 4
Click the TV button, the bed moves to TV position, press and hold TV button
for 5s, until backlight flashes, the control set the current position as TV
position.
1.55 LUMBAR UP 5
Press and hold LUMBAR UP button, Lumbar actuator moves out, stop when
released.
1.6 LUMBAR DOWN 6
Press and hold LUMBAR DOWN button, Lumbar actuator moves in, stop when
released.
1.7M1 7
Click the M1 button, the bed moves to M1 position, press and hold M1 button
for 5s until backlight flashes, the control set the current position as M1
position
1.8M2 8
Click the M2 button, the bed moves to M2 position, press and hold M2 button
for 5s until backlight flashes, the control set the current position a s M2
position
1.9 HEAD UP 9
Press and hold HEAD UP button, head actuator moves out, stop when released.
1.10 HEAD DOWN 10
Press and hold HEAD DOWN button, head actuator moves in, stop when released.
1.11FOOT UP 11
Press and hold FOOT UP button,foot actuator moves out, stop when released.
1.12 FOOT DOWN 12
Press and hold FOOT DOWN button, foot actuator moves in, stop when released.
1.13ZG 13
Click the ZG button, the bed moves to zero Position, press and hold zeroG
button for 5s, until backlight flashes, the control set the current position a
s zero position
1.14HEAD MASSAGE 14
Click the HEAD MASSAGE button, head massage motor switches massage intensity,
massage
intensity switches among 0-1-2-3;
1.15MASSAGE model 15
Click the MASSAGE MODEL button t o change the massage model.
1.16FOOT MASSAGE 16
Click the FOOT MASSAGE button, foot massage motor switches massage intensity,
massage intensityswitches among 0-1-2-3
1.17FLAT 17
Click the FLAT button, the bed goes flat.
1.18 MASSAGE FREQUENT 28Hz
Click the 28Hz button t o set the massage frequent 28Hz.
1.19 MASSAGE FREQUENT 40Hz
Click the 28Hz button to set the massage frequent 40Hz.
1.20 S20
The two remote controls are synchronized wirelessly.
1.2 1S 21
Click the $21 button, the remote control will be paired with the control box.
Federal Communications Commission (FCC) Statement
You are cautioned that changes or modifications not expressly approved by the
part responsible for compliance could void the user’s authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation of the device.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning for Portable device:
The device has been evaluated t o meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Canada, Industry Canada ( I C ) Statement
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
ICED RF exposure statement:
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment.The device has been evaluated to meet general RF
exposure requirement.
| Issue Department: Bedding
Division| Date:| 2022-03-25
---|---|---|---
User manual| Author:|
|
| Edition:| I 1.0
Page 1 of 7
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>