HASWING 50806 Remote Control Instruction Manual

Remote Control
Instruction Manual

Correct operation of the motor

1. Deploying and stowing the motor Deploying the motor
   Press the stow/deploy foot pedal and gently lower the motor taking care to align the lower part of the Depth Collar with the Steering Collar. (Fig. 6)
   Stowing the motor
   Press the stow/deploy foot pedal, grab the handle, head or shaft of the motor, lift and retract , sliding back horizontally until the motor clicks into the cradle.
   When raising or lowering, keep fingers clear of all hinges and pivot points.
   The shaft of the Cayman slides smoothly making it easy to deploy and stow. Do NOT let the motor free-fall when deploying, but gently lower into position,otherwise damage can occur to the Steering Collar.

2. Adjusting the motor’s depth
   Whilst holding the motor by the shaft to prevent it from accidentally sliding, loosen the nut on the Depth Collar and lower the motor to the required depth. Tighten the nut to secure. (Fig. 7)
   When towing the boat with the trolling motor in place, ALWAYS lock the Depth Collar against the gearbox and support the shaft near the head.
   SUGGESTION
   When first using the motor, find the correct depth for general fishing conditions and using a permanent marker, place at mark at the top of the Depth Collar so you can easily set the depth when you next go fishing.

3. Remote control buttons
   

4. Pairing remote to motor
   Press and hold below the battery status lights on the motor (Fig. 8) and (also the Slower button) on the remote at the same time for three (3) seconds or until you hear 3 beeps indicating that connection has been made and the remote and motor are paired. Release fingers from both buttons.
   

5. Mode signal light
   1.Press the “ON” button, indicator light is on solid or flashes, remote control is on “standby” state.
   2.Press any button on the remote control, red indicator light flashes, indicating signal is sending.
   3.Select button, light is two-tone pink/purple, indicating motor is in the anchor (spot lock) mode.
   4.Press “OFF” button to turn of remote control. Light is now off.(Fig. 9)
   NOTE If your press the ON button and there is no indicator light or is solid (N5fEj red, please recharge the remote control as the battery is flat.

6. Speed control
   Press to active motor,click press or to adjust motor speed.
   To switch to full speed please Long press Press again to stop motor.(Fig.10)
   

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>